Skip to main content
2 votes

Temperature gauge needle is on Hot, but engine is not overheating

There are two possibilities I can think of off the top of my head as I recently had a similar problem. One possibility is a partial or complete clogging of the radiator. Another possibillity is that ...
Robert S. Barnes's user avatar
1 vote

At what level does low oil prevent vtec from working?

My Honda with V V T has surged like the Solenoid screen was dirty or solenoid was trying to activate at 2500 RPM.. I've changed the oil, checked the two screens, changed to a little heavier oil. Each ...
Joe M's user avatar
  • 11
1 vote

How does Honda ensure the all the pins and holes are lined up when VTEC is activated? Shouldn't they interfere?

The bottom line on this is, they don't have to line up exactly when VTEC is engaged. The pin which locks the VTEC rocker is pushed against the rocker arm and slides into the hole when it gets to the ...
Pᴀᴜʟsᴛᴇʀ2's user avatar
1 vote
Accepted

Honda Accord 2004 2.4 loud sound after start

It turns out it that the culprit is the metal sheet under the car. I think it’s for heat protection. It was just loosely hanging there. I mounted it back, but it’s just a temporary solution - I guess ...
Dávid Molnár's user avatar
1 vote

Converting standard 2002 civic into a 4V VTEC

The VTEC (D17A2) and non-VTEC (D17A1) of the D17 engines are basically the same engine. In fact, you can run a complete D17A2 VTEC engine in place of the D17A1, except it will never enter VTEC mode. ...
Pᴀᴜʟsᴛᴇʀ2's user avatar
1 vote
Accepted

Honda 2.4 VTEC (2002 CRV): Throwing code P1259 after doing a lot of work on it this weekend

The 1259 code usually comes on because of a switch failure on the vtc solenoid assembly. You can check the screen in the gasket for blockage. Oil control valve failure on these is not as common and ...
Ben's user avatar
  • 10.7k
1 vote

Bolt SITTING in car after Head Gasket repair?? 2005 honda civic won't go above 4,000 rpm

Your mechanic messed something up (or forgot something) as we thought before. It's that shop's responsibility to fix their mistake. Once again, we're talking about a high rpm issue and my first ...
Mustangguy809's user avatar
1 vote

Changing or disabling vtec switchover RPM in 7th generation Honda Accord

There are units that allow you to change the VTEC changeover point without having to replace the entire ECU. Here's one example that's advertised to work with i-VTEC. Otherwise you'd have to ...
Hobbes's user avatar
  • 4,412

Only top scored, non community-wiki answers of a minimum length are eligible