Questions tagged [camshaft-position-sensor]
The camshaft-position-sensor tag has no usage guidance.
8 questions with no upvoted or accepted answers
1
vote
0
answers
43
views
2013 Opel Corsa has the following code “Crankshaft Position ,Camshaft position Correlation Bank 1 sensor A”
P0016 CODE:‘My 2013 Opel Corsa has the following code “Crankshaft Position ,Camshaft position Correlation Bank 1 sensor A”
I got the timing chain done a couple of weeks ago and the code was present ...
- 11
1
vote
1
answer
412
views
Honda Civic 2002 Intermittent camshaft position error
My car experienced a few random cut-offs due to P1361: Top Dead Center Sensor 1 Intermittent Interruption. The first instance happened during a warm day when I turned the AC for the first time in over ...
- 227
1
vote
0
answers
409
views
Corolla 2001 with P1346 code
I have a Corolla 2001 with check engine light code p1346. I had same code about 10 months ago which kinda got fixed by replacing the cam shaft position sensor but i used to see that code as pending ...
- 31
1
vote
0
answers
1k
views
Physically broken camshaft position sensor
The check engine light on my 2006 Toyota Tacoma V6 went on and, when I did OBDII disagnostics, it turned out I had P0348: Camshaft Position Sensor A.
I took the sensor out and it turned to be ...
- 6,767
0
votes
0
answers
109
views
Crank no start!
I have a 2011 Malibu 2LT. It cranks but does not start. It happened all of a sudden with no warning or issues before. Checked fuses and they were all ok, including starter relay and fuel pump relay. ...
- 21
0
votes
0
answers
161
views
New cam sensor - car won't start (Tucson 2006 diesel)
I own a 2006 Hyundai Tucson CRDi 2.0. Starting the engine has become slow recently, and the shop diagnosed it to a bad camshaft sensor. I bought a new one and replaced the old. With the new one in ...
0
votes
0
answers
462
views
E34 BMW V8: unusual CAMshaft sensor signal voltage from ECU
My BMW is an E34 with an M60 engine (OBDI) and one morning started idling and running poorly enough to not be drivable. Unplugging the camshaft sensor with the engine running made no change to the way ...
- 1
0
votes
0
answers
509
views
Hard Starting only when warm - getting camshaft position sensor codes, but have replaced them
Have a 2012 Buick Regal Ecotec 2.4 with 95K miles.
Had engine light with PO340 code to replace camshaft position sensor.
Was getting no drive-ability issues at the time, but replaced sensors.
After a ...
