0

The adjusting end (ball) fell off, and this results in a weak spray stream. I found the part that matches my vehicle on eBay. But, I'm not sure how I would go about replacing it, there doesn't seem to be an easy way to detach it from the arm.

I have a 2013 Toyota Yaris XP13M (NHP13 Variant), with a single front windscreen wiper arm.

enter image description here enter image description here

Improve this question

1 Answer 1

Reset to default
0

A search for replacement procedures returns one Yaris forum. https://www.yarisworld.com/forums/showthread.php?t=63111

Improve this answer
2
  • Are you implying that I should take off the wiper arm to take off the spray nozzle?
    – tutuDajuju
    Commented Oct 29, 2022 at 9:40
  • 1
    Unless the spray nozzle is a separate part that's snapped on and off for replacement by itself, the entire wiper assembly may have be removed to see if a mounting screw is holding the spray attachment. Disconnect the rubber hose and check for a snap tab or mounting screw. Your replacement spray nozzle should give you an idea.
    – F Dryer
    Commented Oct 30, 2022 at 14:36

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .