Timeline for Jacking up a Mk1 Ford Focus around its pinch welds
Current License: CC BY-SA 4.0
11 events
when toggle format | what | by | license | comment | |
---|---|---|---|---|---|
Jun 7 at 13:45 | comment | added | AdamO | The "pinch weld" refers to the entire seam that runs from behind the front wheel to in front of the rear wheel which looks like "pinched" together steel. However, not all the pinch weld is a jackable surface. There is a specific location which is usually circled and described in your owner's manual, reinforced for this purpose. When the manual says to jack from the pinch weld, they refer to the reinforced jacking region in the pinch weld. If you have a trolley jack, the front and rear jacking surfaces are far easier if you can access them. | |
Jul 14, 2021 at 2:29 | comment | added | andy29 | Thank you for the welcome and the answers. I found out a way to avoid the pinch weld in the end - I just don't trust it in the state it's in. Luckily the jack puts the weight on flat metal next to it, so I could lift on that with a block of wood. | |
May 13, 2021 at 18:58 | history | edited | andy29 | CC BY-SA 4.0 |
deleted 1084 characters in body
|
May 13, 2021 at 18:56 | vote | accept | andy29 | ||
May 11, 2021 at 19:36 | history | edited | andy29 | CC BY-SA 4.0 |
Adding more detail to the question
|
May 11, 2021 at 7:46 | comment | added | GdD | With wood I'd be concerned about it slipping off the jack. You can buy ready-made pinch weld adapters, might be the way to go. | |
May 11, 2021 at 7:32 | comment | added | HandyHowie | If you cut a slot in a piece of wood, make sure that the slot is cut across the grain, so that the wood doesn’t split in half. | |
May 11, 2021 at 1:11 | comment | added | Pᴀᴜʟsᴛᴇʀ2♦ | Welcome to Motor Vehicle Maintenance & Repair! | |
May 10, 2021 at 23:59 | answer | added | fred_dot_u | timeline score: 6 | |
May 10, 2021 at 23:27 | review | First posts | |||
May 13, 2021 at 11:18 | |||||
May 10, 2021 at 23:23 | history | asked | andy29 | CC BY-SA 4.0 |