Skip to main content
Michael Sherpa's user avatar
Michael Sherpa's user avatar
Michael Sherpa's user avatar
Michael Sherpa
  • Member for 6 years, 5 months
  • Last seen more than a month ago
3 votes
2 answers
4k views

Cylinder 1 seems to be running hotter than 2,3,4

3 votes
2 answers
999 views

Replacement PCV valve unavailable. Will any other do?

2 votes
1 answer
194 views

Where in a Haynes manual would the compression figures be for my engine?

2 votes
2 answers
7k views

What is the likelihood of a cast iron block needing resurfacing along with its aluminium head?

2 votes
0 answers
681 views

Slipped timing belt. Can hard cranking an engine with cam timing way off likely cause valve damage?

2 votes
1 answer
372 views

Is it possible to have a good looking spark but but still not suitable for ignition?

1 vote
0 answers
65 views

Will alien component found in new engine tear down effect valve behaviour?

1 vote
0 answers
650 views

Misfire! Does good compression mean there are no valve issues?

1 vote
1 answer
96 views

Is it right to presume that the top hose to heater matrix is always the hot hose?

1 vote
1 answer
202 views

Does the Dashpot Piston on an SU Carb effect compression test results with open throttle

0 votes
1 answer
54 views

Should I steer clear of a moped 17 years old only 50 miles on the clock

0 votes
0 answers
72 views

Is there a special procedure for preparing a new but very old stock engine?

0 votes
2 answers
566 views

Would blocking off the heater matrix hoses cause overheating?

0 votes
1 answer
51 views

Why does my van shudder vibrate only after 20mph and only in gear?

0 votes
1 answer
574 views

What's the best approach to install new Timing Belt that's 1/2 a tooth off

0 votes
0 answers
32 views

Is it possible to test an exhaust system for a restriction without dismantling it?

0 votes
1 answer
654 views

Maximum valve clearances. How big is too big?