Martin's user avatar
Martin's user avatar
Martin's user avatar
Martin
  • Member for 7 years, 9 months
  • Last seen this week
  • Italy
0 votes

Putty for exhaust manifold leak

5 votes
Accepted

Rust precautions when enlarging two holes

1 vote

Is it worth refurbishing a metal gasket for a thermostat housing?

7 votes

How Do Parking Brakes Wear Out?

4 votes

Circlip removal when pliers are too large

1 vote

Can deposits on glow plugs be used to diagnose engine problems?

11 votes
Accepted

Is high engine load bad?

4 votes

jacking the engine for timing belt replacement

2 votes

What can cause two deep "stepped" grooves in a rotor?

1 vote
Accepted

What dimensions should the cabin filter have on a Renault Megane 3 BZAF05 - 1.6 cm - 81 kW?

3 votes

Mechanic sent me this image and said my brake rotors should be replaced. Does this seem right?

1 vote
Accepted

The center of my rotor get rusted fast. Do I miss any maintenance step?

0 votes

Removing upside down flange nut in a deep hole

1 vote

Double-stacking thread-repair inserts (helicoils) in the same hole+thread?

1 vote

Seized lug nut, Stud came loose from the hub, Wheel still on. How to remove?

2 votes

unequial drag from front (disc) brakes

6 votes
Accepted

Emergency brake metal latch has snapped off, can it be re-soldered?

0 votes

What can I learn about a vehicle's "health" from analysis of audio recordings?

3 votes

Torque wrench not clicking anticlockwise

8 votes
Accepted

Lifting Support Under Panel BMW

2 votes

Is it normal to over flow little battery liquid

10 votes

Can I use a 15lbs torque wrench for 13lbs spark plug job

1 vote

Can I use the wrong engine oil filler cap?

2 votes

Help!!! $500+Tax for two chewed wires

1 vote
Accepted

Is it cause for concern if an edge seal is missing from my car roof?

7 votes
Accepted

What type of tool has more strength? CR-V (Chrome Vanadium) or those black color tools?

0 votes

Grease gun for preventative maintenance

0 votes

Brake calipers rubbing rim after changing pads

8 votes

How to detach this connector?

1 vote
Accepted

Timing belt location on the pulleys with the new tensioner

1
2 3 4 5
8