Skip to main content
Martin's user avatar
Martin's user avatar
Martin's user avatar
Martin
  • Member for 7 years, 10 months
  • Last seen this week
  • Italy
8 votes

How to detach this connector?

1 vote
Accepted

Timing belt location on the pulleys with the new tensioner

2 votes

Finding correct size for thread repair

3 votes

How do I remove this bolt to replace my MAF sensor?

1 vote

Diagnostic procedure for `98 Camry Night-running Tail-light failure

0 votes

By adding distilled water to AGM battery, it is possible to rejuvenate the battery condition?

1 vote
Accepted

Rotor Diameter for 2012 Chrysler 200

3 votes
Accepted

Torque specs for a plastic thermostat flange

2 votes
Accepted

Torque wrenches of the same force but different head size

1 vote

Lamp Reliability

1 vote

Fuel Resistant Plastics

17 votes

Should I accept this help in fixing a 1" hole in my radiator?

1 vote
Accepted

Does a car battery's acid dissolve nitrile gloves?

2 votes
Accepted

Under what conditions would you consider driving without a fuel tank heat shield?

2 votes
Accepted

Do I need a sealant for a metal gasket on a water pump

1 vote

Replaced Head on Propane Engine; Now I have too high compression. Why?

4 votes
Accepted

Is my mixture too rich?

2 votes
Accepted

Winter Driving in Minnesota: Can lowering a car improve how it handles in on icy / snowy / slippery roads?

0 votes

Should I worry about fuel pump noises after a filter and injector change?

1 vote

What's the right tape to use on split loom tubing?

3 votes

Is EGR valve change necessary?

3 votes

Is there such a thing as a biodegradable (boat propeller shaft) grease?

0 votes

Megane in limp mode, obd reader says p0380, changed all four glow plugs yet same code and issue persists

1 vote

Waterproofing small electronic device on motorcycle

6 votes

Flat tire with sidewall damage, slashing or driving damage?

2 votes

Are these unmarked bolts OK for brake calipers?

1 vote

How to "shine a light into the valve cover" to look for sludge buildup?

2 votes
Accepted

How to remove broken bolt stubs from brake caliper bracket?

44 votes
Accepted

Why do the brakes "freeze" the suspension?

0 votes

Is is safe to wash your engine bay?

1
2
3 4 5
8