tgun926's user avatar
tgun926's user avatar
tgun926's user avatar
tgun926
  • Member for 7 years, 11 months
  • Last seen more than a month ago
18 votes
5 answers
101k views

What should always be replaced when rebuilding an engine?

7 votes
3 answers
33k views

A safe way to turn the engine without a crankshaft pulley tool?

7 votes
1 answer
2k views

What does a wet intake port (direct injection) mean?

6 votes
1 answer
3k views

Extremely over tightened pinch bolt, how to remedy?

5 votes
1 answer
2k views

Ticking noise which gets faster at idle and slows after blipping

5 votes
1 answer
10k views

Do you need to replace injector seals if they are removed from the intake?

5 votes
1 answer
2k views

How to determine component causing overheating?

5 votes
2 answers
939 views

What can be done about an underweight piston?

4 votes
1 answer
1k views

Do injectors leak or injector seals leak?

4 votes
3 answers
6k views

Why is my car hard to start only after a few hours?

4 votes
1 answer
5k views

Can improper coolant concentration increase coolant temperature?

3 votes
2 answers
674 views

Should you hold the clutch in if you slip the clutch too much during a launch?

3 votes
1 answer
2k views

Tell tale signs of a valve cover leak?

3 votes
0 answers
634 views

Is it normal for a used self adjusting clutch to be loose on installation?

3 votes
2 answers
945 views

Can power steering groan be caused by load of AC compressor?

2 votes
2 answers
2k views

How long before failure of engine due to no oil pressure? [closed]

2 votes
2 answers
6k views

How long to let a NA car cool down after hard driving?

2 votes
1 answer
2k views

Will my fuel tank empty if I leave the fuel lines disconnected?

2 votes
2 answers
989 views

Is it bad to continuously turn cruise control on and off?

2 votes
2 answers
151 views

How to ensure even brake pad wear for next time?

2 votes
3 answers
4k views

What problems will I have if I use a rusted input shaft on a transmission?

1 vote
2 answers
157 views

How to fix the threads on a bolt?

1 vote
0 answers
64 views

Car doesn't cold start on first go

0 votes
1 answer
3k views

Properly diagnose coolant leak after head gasket repair?