Hᴇʀʙɪᴇ's user avatar
Hᴇʀʙɪᴇ's user avatar
Hᴇʀʙɪᴇ's user avatar
Hᴇʀʙɪᴇ
  • Member for 8 years
  • Last seen this week
  • Beep!Beep!
21 votes
1 answer
3k views

What does pie cut exhaust mean?

14 votes
5 answers
40k views

Is sand blasting safe on old cars?

13 votes
1 answer
10k views

What is fish plating a frame?

11 votes
4 answers
10k views

If only replacing two tires should they go on the front or back? [duplicate]

10 votes
4 answers
3k views

Does Tig welding a frame add more strength where fish plating isn't required?

10 votes
1 answer
365 views

What can be used to protect the under-carriage of a hot rod?

10 votes
2 answers
3k views

Is there a way to check for rust on a classic car before purchase?

10 votes
4 answers
2k views

Is tire life by mileage a failure point or wear point?

9 votes
2 answers
1k views

Before changing a fuel filter is it ok to let the line run dry?

9 votes
2 answers
6k views

Is it bad on your fuel pump to have your tank run low? [duplicate]

9 votes
2 answers
121 views

Do any internal modifications need to be completed if switching over to a non-standard fuel delivery carb?

8 votes
8 answers
20k views

When loading a car trailer how should the load be set?

8 votes
2 answers
6k views

Will a ground to the frame work properly if the bolt is powder-coated?

7 votes
2 answers
3k views

Is there a way to section a frame without fish plating?

7 votes
3 answers
10k views

How do I fix my Heater & A/C in my car, suspect vacuum problem?

7 votes
1 answer
5k views

When installing air ride suspension how is pinion angle set on the axle?

6 votes
1 answer
253 views

Should a suspension air bag be changed after so many miles?

6 votes
1 answer
15k views

What is the difference between a knuckle and spindle?

5 votes
1 answer
7k views

What is the formula to determine a relay for aftermarket lights?

5 votes
1 answer
280 views

Is a parallel 4 link safe compared to a triangulated 4 link?

4 votes
1 answer
322 views

How can you assure a torque wrench is working properly?

4 votes
1 answer
2k views

Is there a suggested wall thickness for steel tubing when building frames?

4 votes
1 answer
590 views

When getting rotors turned should the thickness be exactly the same throughout?

4 votes
1 answer
71 views

Should a bushing or sealant be used when bolting a gun safe to the cab floor?

4 votes
1 answer
105 views

Can a secondary audio wire harness be spliced into a factory head unit harness?

4 votes
1 answer
4k views

How can the connections of an aftermarket wire harness be joined to a stock harness?

3 votes
1 answer
1k views

How to correct brake pedal click from the interlock solenoid on a Nissan Titan

3 votes
2 answers
11k views

Should loctite be used on suspension components?

3 votes
1 answer
5k views

Where is the Nissan Rogue purge valve?

3 votes
1 answer
900 views

What fuel lines are recommended for a propane carburetor?