24
votes
Accepted
Why one should not leave fingerprints on bulbs and plugs?
Why is this a thing?
For bulbs it is - spark plugs don't care. The problem with getting fingerprints on bulbs (specifically halogen-type bulbs) is actually the grease that gets left behind - the bulb ...
- 9,989
21
votes
Are oils from the skin a problem with turn signal bulbs?
The reason headlight bulbs are so sensitive is their high wattage, halogen design and therefore high heat. Almost all other bulbs in the car are low-wattage incandescent which makes them easier to ...
- 13.3k
17
votes
Accepted
Park/marker lamps won't turn off
I pulled almost every fuse from the fuse block under the dash without any success, but now that it is dark outside I was able to see something I missed when it was day: when I put everything back ...
- 936
13
votes
Accepted
Why are VW tail light bulbs listed as 12W / 5W?
If it is a 21W/5W bulb, then it has 2 filaments of different brightness.
The 5W filament is for the side/tail light for night driving.
The 21W filament is for bright illumination when you press the ...
- 24.9k
12
votes
Smart and effective ways to light up a garage without relying on power outlets?
Battery operated flashlights or worklights which share batteries with your cordless tools would be a good option.
These will allow you to work on the car even with a dead or disconnected battery. ...
- 350
11
votes
Smart and effective ways to light up a garage without relying on power outlets?
There are a number of ways to do this, but the two that come immediately to mind are battery-powered LED work lights. (A quick internet search will turn up many). Two varieties might be of use/...
- 2,847
8
votes
Accepted
How to replace front fog light housing on a Corsa C 2005
EDIT: I have heard that you do not need to remove the entire wing panelling. I certainly didn't on my 2003 Opel Agila. Just remove the screws from the front of the wing on the bottom of the car. Makes ...
- 6,555
8
votes
Why do cars still use mechanical blinker relays?
I can think of several reasons straight away:
Cheap
Easy to replace
Have a very distinctive click that makes it obvious when they are on, and when a bulb has failed
Are very well understood
Anyone ...
- 18.6k
7
votes
Accepted
Motorbike has no power, but kick start works
From looking at your wiring diagram, you have clearly blown your main 15A fuse. This explains why nothing is working from the battery, but once the engine is running, your magneto is powering all the ...
- 24.9k
7
votes
Accepted
Is it Possible to Control Lights through OBD-II Port?
The short answer is: no - not without the manufacturer's diagnostic tools.
The long answer is: maybe. Modern cars have most (if not all) exterior and interior lights controlled by the body control ...
- 86
7
votes
Accepted
Headlight and dome light flickers
This is very common, and not a problem.
When you are starting your car, the load on the battery is huge compared to when the engine is running, as the starter motor is having to turn the crankshaft ...
- 18.6k
7
votes
Can stock headlight wiring deal with 110 W bulbs?
0.85 mm² copper wires have a resistance of about 0.02 ohm/m, and when a current of about 10 A is driven through this wire, it dissipates about 2 W/m. This isn't soo much and should not ...
- 7,047
7
votes
Why one should not leave fingerprints on bulbs and plugs?
Fingerprints on spark plugs aren't a thing, the natural oils on your skin won't affect their operation. If, however, your fingers are covered in car grease or dirt when you handle the plugs then that ...
- 16.2k
6
votes
headlights come on by themselves when car sitting in sun
Possible culprits:
A bad headlight relay
Have the relay tested or replaced. It could be that the switch for the main circuit is intermittently stuck-closed.
A closed-circuit in the light switch or ...
- 39.1k
6
votes
Accepted
Brake lights and turn signals don't work (but head and tail lights do) on 1998 Ford Expedition
On the Expedition the hazard, lower brake lights, and turn signals all route through the multi-function switch.
Gain access to the multi-function switch connector and back probe the light green wire ...
- 10.7k
6
votes
Smart and effective ways to light up a garage without relying on power outlets?
A "dead" car battery can still have more than enough juice to run things like LED lights, phone chargers, etc. - and lots of us have one kicking round the workshop we haven't got round to disposing of....
- 466
6
votes
Accepted
Can stock headlight wiring deal with 110 W bulbs?
TL;DR: You're on the edge, instead of pushing it, use the existing circuit to control a set of relays and supply the bulbs with a short run of larger wire. Use at least 3.3 mm² (12 AWG) wire, which ...
- 14.4k
5
votes
Mini Cooper 2003 - Identify rear indicator light wiring to install LED resistor
I'm going to answer this in a general way because for someone to tell you what the wires mean, they would need to follow this procedure, or have access to detailed wiring diagrams for your car. You'...
- 13.3k
5
votes
Troubleshooting Trailer Lights
It sounds like you have a ground issue. When the running lights are on they are actually grounding through the brake lights. When you apply the brakes it cuts off the ground and the lights go out. The ...
- 16k
5
votes
Vauxhall Zafira rear lights not working
Because stop / tail lights are so important, manufacturers will occasionally split the circuit so that they have a fuse for each side of the car. That way, if the fuse blows, you don't loose all ...
- 23.5k
5
votes
Accepted
What is the formula to determine a relay for aftermarket lights?
You need to know up front what the Amperage of the lights are in the first place and work from there. In the case of the light in the link is has a 72W draw on it. @ 12vdc, this calculates to 6Amps ...
- 153k
5
votes
Accepted
What type of crimping pliers do I need for these connectors
I believe crimping pliers for weather pack, metri-pack, or molex connectors will work. IWISS makes a tool just for those types of connectors. Alternatively, Paladin makes a crimping tool with die ...
- 218
5
votes
Car Bulbs: T10 W5W 501 what do numbers and letters actually mean?
T10
Refers to tubular glass, 10 mm diameter, according to this forum post.
W5W
The W5W defines the bulb "category", which is the standardized filament lamp design, as explained in ECE Regulation 37....
- 39.1k
5
votes
What's this inside my gear shift?
I've seen this before. The bulb assembly usually fits into the gear indicator mechanism in a similar way that brake lights fit into brake light assemblies. That is, usually the bulb socket has a ...
- 2,847
5
votes
Accepted
Difference between orange and orange/silver indicator light
If the indicator lens is colourless, then you will need an orange bulb installed for the indicator to flash orange. If the indicator lens is orange, then it won’t matter whether you install an orange ...
- 24.9k
4
votes
Accepted
Why are taillights usually colored red?
Its a mixture is tradition and function.
Red has been used to signify "Stop" much longer and in many more applications than just motor vehicles. Stop and Do-Not-Enter signs are used everywhere. ...
- 399
4
votes
Mini Cooper 2003 - Identify rear indicator light wiring to install LED resistor
Blue Green is the indicator wire for the left rear, blue brown for the right rear. Assuming USDM.
- 10.7k
4
votes
Battery light on after new alternator
Check the voltage of the white/blue wire at the alternator connector. It should be at least 12 volts if the alternator charging voltage is greater than 13 volts. If there is no voltage here then the ...
- 11.6k
4
votes
Accepted
Brake lights don't illuminate until pedal is pressed by about 5-10mm
Above the pedal should be a button, with 2 wires coming out of it. When your pedal is up, the button will be pressed all the way down, as you press the pedal, be button will release. At some point ...
- 8,443
4
votes
Accepted
2000 Honda Accord - Attempts to start cause lights to go out with no clicking and fails to start
This problem is usually indicative of a bad connection at the battery (or one of the battery cables). It almost behaves like a resettable fuse. When there is a connection, the lights work because the ...
- 153k
Only top scored, non community-wiki answers of a minimum length are eligible