Skip to main content
5 votes

Wheel stuck to Rotor

The easiest way to take care of this which I've found is to: Jack up and secure the vehicle (or wheel) Take all lug nuts off Sit on your butt in front of the offending wheel With your feet, pound ...
Pᴀᴜʟsᴛᴇʀ2's user avatar
3 votes

What can cause a brake light on the Driver side not to work although, the passenger side works

The most likely cause of this is that the bulb has burned out. Unless you have upgraded the tail lights to use LEDs then they will be standard incandescent bulbs which burn out and need replacement ...
GdD's user avatar
  • 17k
3 votes

2002 Dodge Durango brake lights not working

If the "third" brake light is working the switch is okay. The bulbs have been changed, and I assume with the correct bulbs. Has there been any work done recently? Has a trailer hitch been installed? ...
X-tech2's user avatar
  • 789
2 votes

Wheel stuck to Rotor

This is my method of last resort when lube, heat, brute force failed. Loosen all the lug nuts 2-3 turns, alternate between forward and reverse while accelerating 2 or 3 feet in each direction. Hit the ...
mikes's user avatar
  • 19.9k
2 votes

Wheel stuck to Rotor

All I can suggest it to soak the rim with a quality Rust Penetrate, squirt it into the lug nut holes with the lug nuts removed, do this several times a day over a few days, rotate the wheel 180 ...
Moab's user avatar
  • 7,990
2 votes

2003 Dodge Durango - Can I take the front drive shaft off and drive the vehicle?

Most 4x4 vehicles (as opposed to all wheel drive) do not have a differential in the transfer case. The Dodge Durango, has a non-differential transfer case, meaning that the front and rear drive shafts ...
Paul Dufresne's user avatar
2 votes

2002 Dodge Durango brake lights not working

Since the high mount light works it's not the switch. If the tail lights work. Check in the wiring harness in the left rear quarter panel along the frame. More than likely a splice/wire is rotted or ...
Ben's user avatar
  • 10.7k
2 votes

Power drain at fuse panel

This is not a power drain, this is normal. Your battery will sit at ~12.4 V with the car off. You can pull out all the fuses in the world, you can even take the battery out of the vehicle and carry it ...
tlhIngan's user avatar
  • 12.2k
2 votes

2005 Dodge Durango all three break light won’t light up when brake pedal

Brake lights are wired to work independently for safety reasons. If none of the lights are working, the first thing to do is check all the bulbs are good. No reason to start chasing wires if the bulbs ...
CharlieRB's user avatar
  • 9,015
1 vote

Serpentine Belt

Though I want to know what “some repairs” entails, this screams voltage voltage voltage to me. Belt breaks, alternator doesn’t charge, battery voltage drops. 90% percent of the sensors on your car run ...
DieselMech's user avatar
1 vote

Do I have a blown head gasket?

The blown head gasket has prominent symptoms of goo (mixture of engine oil and coolant/water) floating in the coolant overflow bottle. If you visually detect such goo material floating in the ...
user30612's user avatar
  • 257
1 vote

Thin white smoke after getting gas and fuel system cleaning

Update: Turns out the Circle K put diesel in their unleaded tank. So hundreds of people filled their cars up with diesel. Getting our vehicle towed to local dealership and contacted insurance company.
Zlyback's user avatar
  • 31
1 vote

Brake fluid ran dry (ABS system)

yes there is additional bleeding required. From a shop manual:
Moab's user avatar
  • 7,990
1 vote

2005 Dodge Durango all three break light won’t light up when brake pedal

Here is your brake light wiring diagram, might help you diagnose and answer some of your questions.
Moab's user avatar
  • 7,990
1 vote

Ca. Smog Test Problem

Welcome to Vehicle Maintenance & Repair. As you surmise, because the testing rig worked when connected to another vehicle, the test rig is OK. The issue is it won't communicate with your car's ...
DavidRecallsMonica's user avatar
1 vote

04 durango brake light not working after replacing bulb

The fuse is a likely thing to check, but only if none of the brake lights are working because there is only one fuse for both brake lights, and it's located under the hood. It should be fuse #25* in ...
JPhi1618's user avatar
  • 13.2k
1 vote

How come my car won't idle after i changed spark plugs?

I believe what your problem is: you have probably placed the leads to incorrect positions. The leads have to be in exactly the correct order. Even mixing two will probably lead to an engine that will ...
juhist's user avatar
  • 14.6k
1 vote

Weird noise from front right tire

Since you have just performed maintenance on the wheel, there are 3 items you should check immediately The mounting of the brake caliper. Is the caliper bracket secured properly? Is it installed in ...
Eric Urban's user avatar
  • 1,286
1 vote

Dodge Durango Transmission Temperature via OBD2

According to this forum post, you need to do the following: Open up torque on your android device On the main screen hit the settings button (gear shaped button) -settings -manage extra PID's/Sensors ...
Pᴀᴜʟsᴛᴇʀ2's user avatar
1 vote

2002 Dodge Durango brake lights not working

If it is just the brake lights that are not working, the the following could be faulty - Brake switch on the brake pedal - check that it is being actuated by the pedal properly. You cold also bypass ...
HandyHowie's user avatar
  • 25.4k

Only top scored, non community-wiki answers of a minimum length are eligible