Questions tagged [wheel-hub]
The wheel-hub tag has no usage guidance.
8
questions
2
votes
1
answer
76
views
Did I remove this hub bearing wrong? (post-mortem)
I've removed the front left hub bearing assembly on my Subaru. Its the type which bolts in place so you don't need a press.
To get the old one out I used a slide hammer. This was semi-successful - it ...
- 473
1
vote
0
answers
64
views
Scratches on wheel
I have a leased car for work and the wheel got scratched against the curb. Is there a way to get these scratches out of the wheel?
I am quite worried.
Thank you for your help!
Kaitlin
1
vote
2
answers
1k
views
Should you break loose an axle nut with the wheel on the ground?
I've seen in a video the advice to leave the wheel in contact with the ground to prevent rotation while breaking loose the axle nut. The specific example I saw jacked the car up and then lowered it ...
- 473
2
votes
1
answer
886
views
Does an axle nut require a "deep" socket?
I'm going to replace the front wheel bearing / hub assemblies on a Subaru. The axle nut should be 32 mm.
Will a "deep" socket be needed? If its just a matter of the depth of bore of the hub ...
- 473
9
votes
1
answer
2k
views
Alloy wheel really stuck fast to the hub, any practical avoidance steps?
Last night, in the wee small hours, I set about changing the brake discs (rotors) and pads on my 2012 VW Golf.
I lifted the car off the ground and removed all of the wheel bolts. I then found that ...
- 23.5k
2
votes
1
answer
4k
views
What methods are commonly used to remove a rusted and stuck rear wheel hub and bearing assembly?
I have a 2000 hyundai accent and I'm currently unable to remove the wheel hub and bearing assembly on one side due to rust. I'm so close to the finish line, but I am already over budget due to needing ...
- 111
1
vote
2
answers
2k
views
How can you identify if a wheel hub stud is fatigued or stretched?
I know you can tell if a wheel hub stud is damaged based on the condition of its threads. However I have also seen people say you cannot tell the condition of a stud based on visual inspection alone, ...
- 2,736
0
votes
1
answer
598
views
Did wheel bearing need to be removed in order to remove and add new stud?
I previously asked question(What can cause a wheel to fall off/hub to break?) as my wheel hub stud snapped and answers said all that needed doing was putting new studs and nuts in.
Mechanic said ok ...
- 2,736