Questions tagged [two-stroke]

A type of internal combustion engine where all of the cycles of combustion occur in one 360 rotation of the crankshaft.

11 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
173 views

Jet Boat, Cavitation or Misfire?

My jet boat is making a 'putting' noise when trying to accelerate. You can find all details regarding my boat here: My Boat Info The noise seems to happen in the mid-rpm range; 4,000 - 4,800 RPMS, ...
2
votes
0answers
49 views

Does a 2-stroke engine needs "break-in" after replacing cylinder and piston?

I just replaced cylinder and piston (with new gasket, rings, etc) in a 2-stroke 52cc string trimmer engine. It started at the first pull and sounds great, I let it run for 5 minutes, adjusted the carb ...
2
votes
0answers
94 views

Weed Wacker Not Running Properly

I have a Remington weed wacker that is ~2 years old. It worked great for the first 2 or 3 months but then I could not get it to work properly. I have tried new gas, new plug, adjusting the idle on ...
1
vote
0answers
14 views

How can find if the CDI of my bike is working fine?

I have a 2001 Yamaha RX 135 2 stroke motor bike and have installed an aftermarket performance CDI which claimed to give me better performance and RPM rev. But since I have installed it I seem to feel ...
1
vote
0answers
254 views

Johnson 9.9 2 stroke wont idle anymore

I have a 1999 Johnson two-stroke 9 hp outboard motor. I have a 10 foot pelican that I put it on but the other day I almost flipped the boat after making a sharp turn, water got all in the boat about ...
1
vote
0answers
272 views

1997 Mercury 9.9 HP 2-Stroke starting issue

I've been banging my head on a starting issue with the outboard motor mentioned in the subject line (it's a manual pull-start). Problem is that when I pull it over, it doesn't sound/feel like it even ...
0
votes
0answers
58 views

Purpose and correct name of plastic inserts in 2-stroke cylinder

I recently replaced the cylinder and piston on a broken chainsaw 2-stroke engine and I found 2 plastic inserts inside the cylinder. I'm wondering what purpose these serve, and what the correct name ...
0
votes
0answers
24 views

My Two Wheeler scooter - Powers OFF Intermittently while driving

I am using a two wheeler (Petrol/Gasoline vehicle). I haven't driven the vehicle for like 30-40 days. Today I had a trouble turning ON the vehicle. After some tries, I managed to turn it ON ...
0
votes
0answers
34 views

Boring Engine Cylinders

I owned 1978 YAMAHA 175 Enduro (2 stroke) and i had to bore the engine cylinder and now i am using 1.00 piston in it.But i noticed that it's not speeding up above 80,when it reaches 80 it's like ...
0
votes
0answers
9 views

chainsaws&blowers: Any guides/instructions on installing DIY air pre-filters on units with weak OEM filters?

I really love the idea (in link below) of Echo's 'pre-filter' setup to ease/assist the actual/main air filter and would love to DIY something, am guessing a stiff-enough, heat tolerant mesh material ...
0
votes
2answers
2k views

50cc Scooter only runs when manually choking air intake

I bought a 50cc Yamaha Zuma off of craigslist, and it's had some aftermarket parts put on it (exhaust, 70cc big bore kit, new carb). I cleaned the carb and converted the throttle to a one cable set-up ...