Questions tagged [tractor]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
2
votes
1answer
60 views

Ford 4600 diesel tractor

I have a Ford 4600 tractor (3 cylinder diesel) that I have had for a few years. I have replaced the starter, alternator, cleaned up the contacts, changed parts of the electrical system, etc and ...
2
votes
1answer
26 views

White outdoor lawn tractor issue

I have a White Outdoor lawn tractor with Tecumseh engine. I have the following issues and need to find the culprit: Heavy white smoke Oil smell gas There's oil under the air filter and it's leaking ...
0
votes
0answers
12 views

Deutz AgroStar 4.61 wiring plan

I want to build a GPS-based automation steering for my Deutz AgroStar 4.61 tractor. For this I would need some wiring plans to know how I should wire the tractor-electronics with my microprocessor. ...
2
votes
2answers
648 views

Massey Ferguson 240 steering wheel spins without moving the tires

I have a problem with the power steering in my Massey Ferguson 240 tractor, it was really hard to move the steering for the last couple of weeks so I stopped using the tractor to avoid causing any ...
2
votes
1answer
74 views

Water in vehicle tyres

Why are some vehicles tires filled with water? What is the reason behind it. Is it done for all the vehicles or only heavy vehicles?
1
vote
1answer
33 views

How to remove Antonio carraro tire desk?

I am trying to remove tire desk or whatever the part name is, I am guessing that there is some special tool that I don't have to do that, I am afraid to use brute Force and break something, or should ...
1
vote
1answer
213 views

How does the forward and reverse system work on the IH International 845 tractor?

It's not broken, I'm only interested how it works. Pressing the clutch is not needed to operate this handle. It can also take a few seconds before it starts moving.
2
votes
1answer
5k views

Did I blow my engine with too much oil?

I recently changed the oil and filter on my 2007 Sears tractor. I put in 64 oz as instructed. The tractor ran about 45 minutes, I mowed the lawn. No problems. 3 days later I went to mow again, and ...
2
votes
1answer
401 views

Thickness of aluminium on Alcoa type forged aluminium wheels.

Is there a good estimate of the thickness of the aluminium on Alcoa forged aluminium semi wheels 22.5 type. Figures need not be precise, or just a range, for estimates, is 1/2 an inch a good estimate ...
2
votes
1answer
534 views

What's the starter current for an old 3-cylinder diesel tractor?

Just today we had to move a Deutz D40.2 (1962 or so) out of the way and the battery (something like 12V 130Ah or so) wasn't up to it. So I first tried helping out with a just-charged car battery (12V ...
9
votes
3answers
4k views

What is the name for the spoiler above the cabin of a semi?

This diagram is from Wikipedia. I am interested in what people call the part marked 6 on the diagram. The label suggests it is called an "air dam", but searching around, that term seems to be used ...
6
votes
1answer
6k views

Lawn tractor, difficulty starting in cold weather

I have a Troy Bilt Bronco riding tractor, about 6 years young, with a Kohler Courage 20 (19hp) engine that is extremely difficult to start in temperatures below 40F. This is a persistent problem. ...
8
votes
2answers
1k views

Accidentally poured gas into antifreeze in tractor

I was gonna fill our tractor with gas and there were to caps, a metal one a d a filter looking one, neither was labeled so I figured the metal cap was the gas cap, I put gas in it for just a few ...
7
votes
1answer
408 views

Starting a diesel tractor

I have a diesel tractor with a generator. After sitting for a long period the battery was low so I used a portable jumper battery but mistakenly hooked up the cables in reverse. This caused smoke to ...
4
votes
1answer
479 views

What make and model carburetor does a Farmall H tractor have?

I've been asked to find parts for a Farmall H Tractor carb. None of the searches I try identify the Make and Model. I believe the engine is an IH C152. I can see that the same carb is used on an H, ...
6
votes
1answer
362 views

john deere sx75

My SX75 was moving when it stopped. It does not move forward or backwards. The clutch pedal feels fine. If i put it in gear with the tractor off it cannot be pushed forward or backwards (trans engaged)...
9
votes
1answer
431 views

Ford Tractor 5600

This is a older tractor. My question relates to the fuel system. The older fuel injectors don't have any external seals? All of them seat and 3 don't leak but one does. I was looking for a seal but ...
3
votes
1answer
57 views

Does anybody know what this is?

I was admiring my grandpa's John Deere 5203 tractor today and saw this. I'm pretty sure that's the throttle connected to the spring-hinge, so I'm guessing it's some kinda fuel injection. However, I ...
4
votes
1answer
928 views

Cannot get Kubota tractor engine to fire

I have a Kubota T2080 lawn tractor. It has a basic 2-cylinder gasoline naturally aspirated engine. I let it sit last winter and now that it's the spring, I cannot get the engine to fire. The electric ...
3
votes
1answer
495 views

tractor to small engine with gear reduction

I want to run an implement requiring a minimum of 35 hp at 540 rpm with a small engine running 3600 rpm with a 6:1 gear reduction. What horsepower engine would be required to get the min hp to run the ...
2
votes
1answer
831 views

roots blower pressure on Detroit 2 cycle Diesel 371 cubic inches

I need the blower pressure for a Detroit 2 cycle Diesel 371 cubic inch Oliver 99 tractor
12
votes
1answer
12k views

How important is it to use a real flare nut wrench when removing the fuel line on an old Ford tractor?

An article on overhauling the carbs on a Ford 8N tractor says to use a flare nut wrench to disconnect the fuel line. How important is it use that kind of wrench, vs. an open ended wrench?