Questions tagged [throttle-body]
The throttle-body tag has no usage guidance.
9
questions with no upvoted or accepted answers
7
votes
2answers
193 views
How much oversize should you target when choosing a throttlebody?
This is in addition to my previous question about throttle bodies. I know it may sound a bit subjective, but I think it has a clear technical aspect, and I have done a considerable amount of homework.
...
2
votes
0answers
278 views
Sportbike Throttle Body Out of Sync
I recently purchased a 2017 R6. At around ~450 miles I had the 600 mile maintenance done early because I noticed my bike wasn't shifting as smoothly and the engine wasn't running as smoothly (running ...
1
vote
2answers
272 views
Differences between drive by wire and drive by cable
What are the main differences, advantages, and disadvantages of using a drive-by-wire versus drive-by-cable system?
1
vote
1answer
53 views
Do I need injection, throttle body, and upper intake cleaning?
I have a 2014 Toyota Camry with 52k miles.
The last 2 times I've gone to the dealership for regular oil change and maintenance checkups, they've tried to get me to do an injection, throttle body, and ...
1
vote
0answers
99 views
Throttle Body is not close/open smooth?
i have hesitate RPM . today i check my Throttle Body and i think is not close/open smooth. its feel lag when pressing pedal slowly. or its okay? what you think?
Visit https://www.youtube.com/watch?v=...
1
vote
0answers
34 views
Engine stalls if giving gas (just for about 20 seconds after startup)
When I start my Peugeot 106, it will idle fine, but if I give gas it will stall. If I give just a bit of gas, after about 20 seconds the engine starts to run properly. I unmounted and cleaned the ...
1
vote
0answers
840 views
Throttle body cleaner on rubber bad?
Was cleaning my throttle body and IACV using throttle body cleaner not brake cleaner and some dripped onto coolant rubber hoses and the IACV gasket.
Would this cause any damage? Make the rubber ...
0
votes
0answers
9 views
My Mazda 3 2006 runs and idles but has no power at pedal
I have replaced the throttle body.. Pedal sensor. Mass air flow and battery and relay. Tried the throttle relearn and still nothing
0
votes
0answers
2k views
If I don't have throttle body cleaner, what can I safely use as an alternative?
Pretty much as the title states, I need to clean my throttle body, but I don't have any 'throttle body cleaner'.
Are there any other common solvents I could use instead, that would be both effective ...
