Skip to main content

Questions tagged [steering]

Questions about the steering system of a vehicle, including the wheel, column, rack, and linkages. For power steering specific questions, use the 'power-steering' tag

Filter by
Sorted by
Tagged with
11 votes
5 answers
25k views

Aligning a castle nut with a torque spec to a cotter pin hole

The nuts at the knuckle on my outer tie rod ends are castle nuts, which are locked by cotter pins fed through holes in the studs. The nuts also have a torque spec (27.0±2.5 N∙m, in this case). If I ...
jscs's user avatar
  • 1,423
9 votes
6 answers
58k views

Should I leave my wheels straight when I park my car?

I was told that I should leave my wheels straight when I park my car on flat driveway, I think this is rubbish and it doesn't matter personally Should I leave my wheels straight when I'm parked? ...
George's user avatar
  • 6,555
7 votes
1 answer
3k views

Outer Tie-rod removal

UPDATE: Both tie rods were removed by unscrewing the inner tie-rod from vehicle: rotated steering wheel to maximum to improve access removed bellows boot to expose wrench-able area of inner tie rod ...
gatorback's user avatar
  • 1,267
5 votes
1 answer
867 views

Clunking sound?

I just purchased a previously owned 2008 Chevrolet Malibu with 100,000 K on it. Whenever I make a sharp left or right turn (making a 90 degree turn rather than a shallow turn), the front end makes a ...
Branden Henry's user avatar
5 votes
1 answer
6k views

Can I break power steering by turning too far

Will I damage power steering in a 2008 Camry XLE if I routinely turn the steering wheel to its limits, i.e. where it will not move further?
Simon Kuang's user avatar
11 votes
5 answers
108k views

Steering wheel "center" different from vehicle "straight"

I just had a 4 wheel alignment done on a vehicle. While taking it for a test drive, I noticed that the steering wheel is not quite centered for the vehicle to drive straight. It's not pulling in ...
End Antisemitic Hate's user avatar
7 votes
2 answers
1k views

control car's steering angle from linux

I'm trying to send steering wheel angle commands to my car. It's a fairly recent car (Renault Espace IV). I'm using an OBD2 port to access it, and I also have a ShieldCan. I managed to read data from ...
Graham Slick's user avatar
6 votes
1 answer
8k views

what is exactly steering feedback?

I have heard people say that cars with HPS and Non PS have nice steering feedback while the other cars with EPS steering's have vague feeling and has no feedback at all.I have driven few cars, A fiat ...
saurabh64's user avatar
  • 1,072
6 votes
2 answers
2k views

Difficulty removing Outer Tie Rod from steering knuckle

On my '95 Acura Integra LS, the driver's side outer tie rod is embedded in the steering knuckle. I am unable to loosen the jam-nut. How do I remove the outer tie rod from the steering knuckle? ...
gatorback's user avatar
  • 1,267
5 votes
1 answer
5k views

Replacing Rack & Pinion Seal

I'm working on a 98 Honda Civic. I'm attempting to replace the inner seals. These are the seals which the steering rod rides on and which keeps the power steering fluid in check at that point. Here is ...
Pᴀᴜʟsᴛᴇʀ2's user avatar
4 votes
5 answers
34k views

Squeaky steering?

Before going off to college, I had my car carefully inspected by a trusted mechanic whom I asked to inform me of any major problems. That is to say, the car has none now. However, I just noticed (don'...
temporary_user_name's user avatar
3 votes
2 answers
302 views

Is four-wheel steering used for lane-change maneuvers in any production cars?

I have read that some form of four-wheel steering is a feature on a number of production cars, but I haven't been able to find details of those systems. I'm particularly interested in whether four-...
feetwet's user avatar
  • 1,199
2 votes
1 answer
99 views

Steering wheel misaligned to the left *only* after making a left turn

Vehicle is a 2002 Toyota Sequoia SR5 4WD. For as long as I can remember while owning this vehicle (about 3 years) the steering wheel is cocked to the left, maybe 20 degrees or so while driving ...
Luke's user avatar
  • 121
2 votes
1 answer
634 views

Car pulls left, rattles very hard, steering wheel not straight when going straight

I recently noticed several problems with my 2019 Diesel Land cruiser J150 (called Prado elsewhere): When I go straight and let go of the steering it goes left fairly hard, have to constantly apply ...
user1721135's user avatar
2 votes
1 answer
10k views

Is it normal to hear noise from brakes when turning the steering wheel at standstill?

I have an approximately half year old 2016 Toyota RAV4 hybrid. If I am stopped when pressing the brake and turning the steering wheel, I hear noise coming apparently from the front brakes. If I ...
juhist's user avatar
  • 15k
1 vote
1 answer
136 views

Why does steering wheel shudder when applying brake?

I'm driving honda civic 2009, with new tires, new tie rods, new brake rotors, new brake pads, wheel balancing is also done. When applying brake, at speed of 40km/hr or above, the steering wheel ...
variable's user avatar
  • 161
1 vote
1 answer
104 views

Steering wheel off center after tight turns

Car is a Mk1 Golf/Rabbit Cabriolet. When I do a tight turn, eg a U turn, upon centering the car again the steering wheel is about 45 degrees off center even though the car tracks correctly. I can &...
MeltingDog's user avatar
  • 3,760
1 vote
3 answers
12k views

Shake while braking at certain speeds, intensified with steering input

150k miles 2.0l gas mkIV Jetta, 5-speed manual. Braking at speeds of around 40mph down to 20mph there is shake in steering and overall jerky stopping. If slight steering is added(say gentle off-ramp-...
Joseph S's user avatar
0 votes
1 answer
42 views

Steering clunk - 2012 Audi Q5

My wife's 2012 Audi Q5 has recently started making a 'clunk' noise/feeling when turning the steering wheel. It happens both when moving & when stationary and the 'clunk' occurs roughly every 180 ...
brhans's user avatar
  • 167