Questions tagged [obd]

An acronym; On Board Diagnostics.

31 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
5
votes
0answers
2k views

On Board Diagnostics-II for Electric Vehicles

I'm learning about OBDII, and I'm wondering whether it is valid on EV's too. According to Wikipedia's PIDs article, the Service 01 PID 51 (or Fuel Type) has a value 8 that means that the fuel type ...
5
votes
0answers
1k views

Difference between FMS and OBD

What is the difference between FMS and OBD. Whether OBD is a standard or protocol. Recently I am working on a GPS device to tap the CAN bus in order to integrate with our fleet management system. In ...
4
votes
0answers
298 views

CAN data for Mahindra

I bought a new Mahindra Scorpio S10 and have been trying to read the CAN bus using ELM 327 Bluetooth OBD and Putty. Configurations in Putty: Baud Rate 9600 (tried 115200 also), Data bits: 10, Stop ...
3
votes
0answers
51 views

Less than specified bytes of data from OBD

0100 (https://en.wikipedia.org/wiki/OBD-II_PIDs#Mode_1_PID_00) should provide 4 bytes of data. But there has been cases, like Audi A4 2.0 TDI, where the data from 0100 was less than 4 bytes. So is the ...
3
votes
0answers
292 views

SilLabs OBDscan can't connect to Alfa 147: latency too high!

I have an OBD Scan tools built around the Silicon Labs CP210x chipset, but I can't get it to connect to my car at all. When I connect the scan tool to my laptop USB port I have a driver installed and ...
3
votes
0answers
10k views

Reading OBD Data from the Old Honda 2+3 Pin DLC

I've got a 2000 Honda Civic iSR with the old 2+3 pin Honda DLC which I'd like to read ECU data from. According to the Evoscan website the pinout for the 3 pin dlc is ISO 9141 K-Line, B+ and ground ...
3
votes
0answers
439 views

2005 Impala OBD2 not working right

I have a 2005 Chevrolet Impala (Base trim, 3.4L) and I recently purchased a cheap OBD2 Bluetooth reader. Unfortunately, Torque (Android app) isn't able to read data from this transmitter when ...
2
votes
0answers
33 views

Bmw N52N Lambda probes madness

Owner of a BMW E60 523i LCI Automatic (N52N engine. aka N52k). 105000 Kms on the clock. The error codes below after deletion, re-appear after 300~400 Kms. It is theoritically impossible for 4 lambda ...
2
votes
0answers
1k views

Can an OBD2 device be used to limit vehicle speed?

Is it possible? And if so, which OBD2 device can do it?
2
votes
0answers
734 views

Catalyst Temperature

Please refer to Catalyst Temperature PIDs (mode 01 pids 3C, 3D, 3E, 3F) for the following questions - https://en.wikipedia.org/wiki/OBD-II_PIDs#Mode_01 Q1. Is there a thumb rule that the catalyst ...
2
votes
0answers
1k views

What is the difference between Toyota GTS and TIS software?

I've found two types of Toyota OEM software available. One is the GTS ( Global Tech Stream ) software which is freely available from Toyota's EU site. The other is the Toyota TIS ( Technical ...
1
vote
2answers
71 views

obd2 device on obd1 vehicle?

is there any way to make a obd2 plug in device (example gps tracker Metro Smart Ride) work on a obd1 vehicle. The device works and still has service. I no longer own a vehicle with obd2, but I'd still ...
1
vote
0answers
15 views

Incomplete Monitors

I changed my Hyundai 2000 Accent battery and My CAT and EVAP monitors will not complete. I have tried a generic drive cycle and monitors will not complete. Any suggestions.
1
vote
1answer
136 views

OBD2 port construction, Toyota Camry 95, and Dodge Durango 2002

I have a product that takes an OBD 2 plug for power and I don't want to use my standard OBD port. I need to create an OBD 2 port for power purposes only, how could I do this and does the port run at ...
1
vote
0answers
147 views

Problem diagnostic on Toyota Estima

In relation to my previous question: Hybrid battery not charging fully This morning I took the vehicle to the mechanic who has serviced all of my cars for the last 10 years. He called me later in ...
1
vote
0answers
781 views

P0340 code, even after camshaft sensor replacement [Solved]

I drive a 2004 Honda Civic ex coupe manual with ABS, engine code D17A2 (SOHC, Vtec) I was driving my car and slowly revved up to 7krpm (smart, I realize) and suddenly my car lost power until 3500rpm ...
1
vote
2answers
397 views

OBD2 device that connects over cellular data?

I'm looking to monitor any and all stats of my vehicle. Are there any OBD devices that connect remotely over cellular data, and come with a nice phone app? I'd like to be able to monitor the car from ...
1
vote
0answers
14 views

Konnwei kw30 diagnostic equipment

Just got a konnwei kw830 diagnostic tool I plug it into my car which I know has a fault as I have checked on another system and that comes up with fault key 1 which means my car key has lost its ...
1
vote
1answer
155 views

How difficult is it to collect obd commands ?Will it be different for different brands?

OBD is something very interesting I found these days.Thanks to this repo https://github.com/pires/obd-java-api & wikipedia which provides the basic information of PIDs.But there is a lot of ...
1
vote
0answers
44 views

Where are the Logics and Data of the OBD System Stored?

I'm wondering if OBD Data is stored and processed on it's own board or integrated into other systems, or both. Or neither. Wikipedia just confused me further. What I got out of the wiki is that OBD ...
1
vote
0answers
250 views

Trying to access mode 22 data

I'm trying to get mode 22 diagnostic data from my 2006 Chrysler Sebring 2.7L and more specifically the misfire counts for each cylinder. I have an ELM327 that I'm using. My car uses the J1850 VPW ...
1
vote
0answers
30 views

CAN Signals on OBDII

What CAN messages & signals are freely accessible through OBD-II? Can manufacturer close certain signals or only propretary ones? I know all CAN signals can be accessed but not interpreted ...
1
vote
0answers
1k views

Calculate Intake Manifold Absolute Pressure from MAF Engine using OBD Data

I need to calculate Intake Manifold Absolute Pressure from OBD Data. I have Toyota Corolla GLI 2010 Model. This car has MAF engine which does not return Intake Manifold Absolute Pressure. Where'as I ...
0
votes
0answers
31 views

How and what would I get from a car rain sensor?

I am looking for an answer on how to acquire data for the vehicle rain sensor and automatic wiper data from any vehicle. For example, I know that with Carberry (a Raspberry Pi) it provides a lot of ...
0
votes
1answer
41 views

Can anyone offer advice on MUTILPLE codes all seeming to deal with my transmission

2001 Ford Taurus Wagon with 124K miles Duratec engine Drive car yesterday and everything seemed fine. Came home and parked it like always. Today the car runs but both the check engine light and the ...
0
votes
1answer
36 views

Obd2 not working, need to rewire

1996 chevy p30 5.7L Obd port wasn't working. After I looked under the dash it's apparent someone has cut all the wires and never wires them back in. I guess there was front end damage so I assume they ...
0
votes
0answers
189 views

How do I factory reset an OBD2 ELM327 device (not reset ECU)?

it no longer puts out wifi thank you tried turnning it off for a day, it has no reset button on the unit or PCB here is more information: Here is more information https://security.stackexchange.com/...
0
votes
4answers
2k views

How to power up OBD device without ignition to vehicle?

i would like to power on the obd device without ignition to vehicle. Am trying to establish some connection for programming work buy connecting to my laptop. Any way to do this?
0
votes
0answers
48 views

Car hacking - e.g. auto closing windows when locking

Im new to car hacking. I want to modify my car. The target is that the windows close automatically when i lock the car. I found out that I can use the CAN2USB Device to connect the car to a linux ...
0
votes
0answers
87 views

Truck's exhaust temperature: how to read EGT sensor by ODB / FMS / Can-bus?

I succesfully decoded can-bus data from a VW Caddy, but know nothing about OBD and trucks. For a research I need now to read a truck's exhaust temperature (EGT sensor), possibly by OBD. I would ...
0
votes
1answer
421 views

OBD2 expert in ipad to bluetooth elm327 mini

Just bought OBD expert on grounds good to go in an ipad (version 9.3.5 13G36) It just wont detect the adapter from my ipad. Adapter is fitted and red light on. Am I wasting my time with an ipad and ...