Questions tagged [mustang]
The Mustang is an American automobile manufactured by Ford, which has been in continuous production since march 1964.
28
questions with no upvoted or accepted answers
7
votes
2
answers
806
views
Audible clicking at high speeds - what could it be?
I just recently started hearing an audible clicking sound in my 2015 Ford Mustang Ecoboost.
I only hear it in 3rd and 4th gear and only when I'm at about 3.5k rpm and higher. (I originally just ...
4
votes
0
answers
105
views
1998 Ford Mustang jerks badly on acceleration after I shift gears
When shifting my 5-speed from 1st to 2nd gear there's no problem, but when I go to press on the throttle after shifting I feel a jerk. I have adjusted the clutch cable after replacing the broken one. ...
4
votes
0
answers
2k
views
Mustang 95 hand brake and abs problem lights on
(Sorry for my lack of mechanical English experience)
I just bought a 95 Mustang. When I made my first test drive all was well, except a problem with my disc brake (they aren't even) but this doesn't ...
- 141
3
votes
0
answers
204
views
4.6L DOHC Ticking Noise
Have a terminator cobra with very low miles (5000) that has an odd issue. The engine starts ticking at 210F coolant temp (normal operating temp), and only at idle. No tick is heard on cold start, but ...
- 31
2
votes
0
answers
46
views
No crank or start
I have a 2001 Ford Mustang and I put a new ignition locking cylinder and and a different ignition housing and a new antenna immobilizer and I even have the chipped key attached to the antenna ...
- 21
2
votes
0
answers
37
views
98 Mustang Randomly loses power w/ gas smell
So when I'm driving around, and specifically when it's humid as I've noticed, my car will randomly lose power and when at a constant speed, start lurching back and forth. Every time this happens, all ...
2
votes
0
answers
2k
views
2003 Ford Mustang 3.8l v6 oil pan removal
changing out the rod bearings on my first car. I read on ALLDATA that I have to lower the front subframe to get the oil pan out from under the car because it is right above the subframe. However, it ...
- 357
2
votes
0
answers
76
views
Rear Noise when reversing then accelerating slowly
A week ago, I noticed a noise coming from the rear when I reverse and press on the gas and then it slowly disappears when increasing rpms. I just had the rear main seal replaced last week. Please help....
- 21
1
vote
0
answers
29
views
2012 V6 Mustang Loses Power when Accelerating
I've noticed recently that my 2012 v6 Mustang loses power when accelerating, but only in 4th gear. This happens when I'm getting on the highway since that's the only time I'm accelerating hard in 4th ...
- 11
1
vote
1
answer
57
views
1971 Mach 1 Mustang
I own a 1971 Mach 1 Mustang. Owned it since 1975.
Just got it out of the shop. Ran great. Then started making pop sound/and hesitation. Thought it might be carburetor.
Today, I Cranked it up, it blew ...
- 11
1
vote
1
answer
55
views
My car randomly won’t start
Don’t know if my transponder is going out in my key or if it’s a fuse can some one help. When I try to start the car the millage area goes from numbers to dashes - - and the starter never turns.
- 11
1
vote
1
answer
106
views
EGR was deleted. Is this the EGR line?
Someone who owned my 1986 3.8l Mustang before me decided to delete the EGR system. I'm attempting to get this car to pass emissions so I want to reinstall the EGR system. However I want to make sure I'...
- 34
1
vote
0
answers
57
views
Less oil on certain valves than others
I've got a 1986 3.8l 6-cylinder mustang. I've been hearing a ticking underneath the driver's side valve cover, so I took it off. I didn't see anything wrong so I started the engine sans valve cover. ...
- 34
1
vote
1
answer
952
views
RPM dropping after refueling
It only happens when I refuel and then drive and everytime I come to a complete stop it drops RPM from a normal 1k to 500 and then goes back up to 1k I am not sure what’s wrong I use 93 premium ...
1
vote
0
answers
20
views
1968 I-6 swap questions about the spindles and or any tips/ etc
I have a original inline 6 that I’m swapping with a 302 I already have a c-4 trans that is in the car currently, I know of swapping the front end and what I have to do for the extra weight but (not ...
- 11
1
vote
1
answer
83
views
Head bolt replacement on a Mustang gt 2005
I had the engine on the car rebuilt and when the shop tried to start the car they found out that they had to use new phaser bolts. In less than 10,000 kilometers the engine is overheating and I ...
1
vote
1
answer
343
views
Intermittent loss of electrical power on a Ford Mustang
This is a 1999 Ford Mustang GT 4.6.
Electrical power completely shuts down and comes back on, the dashboard lights and gauges go crazy.
I put in a new battery, alternator and negative cable and ...
- 11
1
vote
0
answers
137
views
One headlight stuck in high beam mode + other electrical gremlins after head unit install
This is a 2002 Ford Mustang base model.
One of my headlights is stuck on high beams the other is on low. When I turn my high beams on both are high.
Not sure if this has anything to do with it but ...
1
vote
0
answers
123
views
Why won't my Mustang move in 1st, 2nd, 3rd gear after clutch change?
My mustang will not move in first or second or 3rd gear but will in 4th gear. I really need some advice regarding the issue. It is rattling when the pedal isn't engaged.
I recently paid for a new ...
- 11
1
vote
1
answer
161
views
new stage 1 clutch slipping after upgrading mag size?
~I installed a stage 1 clutch kit on my 07 Mustang v6.
As long as the mags are 17's there is no issue, but as soon as I went to 18" with sticky pirelli's... the brand new clutch slips and over revs ...
- 11
1
vote
0
answers
72
views
66 mustang automatic (3 speed) adding fluid after removing pan gasket
What I've done so far to the trans:
removed pan
replaced filter
replaced pan gasket
put it back together
Issues:
I have a bad torque converter (lurches then stalls when selecting gear)
no idea if i ...
- 11
0
votes
0
answers
50
views
2008 Mustang Cabin Leak and “Check Charging System”
Went to go run some errands today and my 2008 Mustang wouldn’t start. Didn’t even sound like the engine was trying to turn over. Lights flashed inside and CD player went absolutely ballistic. The dash ...
0
votes
0
answers
88
views
Why doesn't my engine rev up when closing choke valve?
So I just installed a manual choke cable on my Mustang 1967 (Holley carb 4 bbl), and upon startup I pull the choke and see the valve close but the engine does not rev up at all. I go as much as to ...
- 113
0
votes
0
answers
160
views
2019 Mustang Convertible rear window sticking
Raising the rear windows with top closed, the driver side rear will stick. I can pull it up with my hand. General internet solution is to lubricate it, usually silicone lube recommended. The lube ...
- 1
0
votes
1
answer
66
views
A/c gauge temp doing weird. Sky coupe gt 350
I have a gt350 coupe and I know when I am parked with the a/c on it will overheat in an hour, so I need to turn a/c off. But this time while driving the temperature gauge started going down, not ...
- 1
0
votes
0
answers
45
views
What can be faulty on my clutch system ? Mustang '67
I've ran out of ideas, haven't had the time to go under the car so I would like to know your opinion. I was riding my '67 Mustang, until gears suddenly felt stiff to engage, afterwards I realized the ...
- 113
0
votes
0
answers
120
views
1971 Mach 1 Mustang Overheating issues
Just recently purchase a partially restored 71 Mustang with an aftermarket 460 crate engine And a C6 transmission. Most of the restore has been on the outside of the vehicle and its in good condition ...
0
votes
0
answers
25
views
Convertible's motor (likely) damaged
I own a 2013 Convertible Mustang. A couple of months ago, it had been raining heavily where I live. I started seeing water near the panel near the passenger seat whenever I'd drive. I was later told ...
- 101