Questions tagged [motor-mounts]

Parts that used to attach the engine and transmission to the frame of a vehicle. Usually made from rubber that acts as a vibration dampener.

10 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
331 views

2001 Toyota Rav4 O2 sensor change

When changing O2 sensor B1 S2 on 2001 rav4 do you have to loosen the engine mount to access sensor with o2 socket, or is there an easier way?
1
vote
0answers
24 views

How do I move engine back to line up motor mount bolts 06 Subaru outback

so I just replaced my valve cover gaskets due to them leaking pretty bad. To get them out (without removing engine) I had to unbolt the motor from mounts and jack the engine up a few inches to get ...
1
vote
0answers
24 views

Motor mount went

Aftermarket rear motor mount went on my Fiesta. Reason I knew right away was driving along a lot more vibration and banging on downshifts. As I pulled up, 2 miles later, I left the car overnight and ...
1
vote
0answers
47 views

Car Jerk when switched to Drive and Engine Bangs (Knock) over bumps

I have Nissan Teana 230JM (J31) 2007 model. The issue i am facing is when I start the car in the morning then it takes some time to shift to Drive, So I have to switch it to 1st and then drive a ...
1
vote
0answers
171 views

Car shuddering, losing power

I have a VX Commodore 2000. A few times over the last few days it started to shudder as I reversed into a park and was about to conk out as I switched it off, then later as I drove home it started to ...
1
vote
0answers
80 views

Where to locate engine mounts on Nissan Note 2006 HR15 Engine?

My engine started slightly vibrating when the car is in drive and i am fully braked, and I believe it to be one of the engine mounts. Problem is, I don't know where the left engine mount is. I can ...
0
votes
0answers
16 views

05 Acura RSX type s engine mount failure

Passenger side engine mount has failed 3 times after Clutch replacement each time mount was replaced with a new one that exceed OE specifications. What is causing the mount failure?
0
votes
0answers
88 views

Yamaha Nmax what causes excessive scooter seat vibration?

I have an app that records motorcycle seat vibration and shock. While doing a test run on Yamaha NMax I have observed shock readings from the seat that are inconsistent with the ride quality. The bike ...
0
votes
1answer
51 views

engine mount bolt torque (Ecotec)

('07 Cobalt LS, 2.2 L) Re the passenger side engine mounts, ... The Alldata manual (AIUI, from Helm) says Tighten the engine mount to body nuts to 66 N.m (49 lb ft). Tighten the engine mount to ...
0
votes
0answers
40 views

CVT car still shaking when shifting to a gear setting at idle after taking it to a couple mechanics

Overview: So I have a Suzuki Celerio 2014 CVT that vibrates really bad whenever we shift to a gear at idle. If we shift it back to either Neutral or Park, the vibration stops completely and ...