Questions tagged [moped]

A two wheeled motor vehicle which incorporates pedals similar to a bicycle as a component of it's final drive system.

Filter by
Sorted by
Tagged with
0 votes
0 answers
103 views

moped gy6 50cc starts idles for 3 seconds then dies

So I just got a Zeniin A9 2019 moped. the guy before he had replaced the whole starting system due to someone telling him it's the stator causing the bike to run then as soon as it gets warm it like ...
Logan Bangart's user avatar
3 votes
0 answers
69 views

Remove coating from chrome headlights

I'm restoring an old moped. It's a 1964 NSU Quickly N23. One of the next steps on my restoration project is to work on the paint and chrome parts. My headlights are covered with a layer of paint. I'm ...
Lizzy's user avatar
  • 31
0 votes
0 answers
114 views

How do I stop a gas leak from my 150cc ice bear scooter?

Gas leak on 150cc motor scooter I was riding then my engine stalled out then died and gas was leaking and burning on my muffler
Christopher's user avatar
1 vote
0 answers
307 views

Tomos A3 K Starts but engine has no 'power'

So I recently inherited an old Tomos moped [Model A3K with an Encarwi carb] that has been sitting in a garage for a few years and decided to fix it up as a summer project. I've gotten it to start ...
Spam Tastic's user avatar
0 votes
1 answer
76 views

Will a motor scooter leak when tilted at 45°

My family is moving and the movers loaded our Honda Ruckus into the truck with the front wheel raised to make a 45° angle. Could this cause any fluids to leak?
TechDragon's user avatar
1 vote
1 answer
258 views

Float doesn’t work Yamaha Vino

I recently wrecked my Yamaha vino and while I’m trying to replace some parts I thought I would fix the fuel gauge (which hasn’t worked since I got the scooter a year ago.) I took the sensor out to ...
Matthew Quinn's user avatar
0 votes
0 answers
709 views

Scooter stalling when idle and warm

I have a 50cc scooter gy6 and it dies when stopping at traffic lights or when idle in general. it has a brand new carburator. Things I have noticed: When it is cold it does not do it that often but ...
Dionysis Nt.'s user avatar
1 vote
2 answers
2k views

50cc sinnis street moped revs but does not move

So basically I just had an issue with my moped. I was riding it when it suddenly wobbled and stopped. When it stopped it didn't turn off it was on but when I reved it it didn't move, am suspecting the ...
momo 's user avatar
  • 11
1 vote
3 answers
1k views

Three New TaoTao 49cc mopeds won't start. Two new carbs . Engine not getting gas, Have checked everything. Runs with choke or starting fuid

I have Tried everything to start these TaoTao 49 cc Mopeds. bypassed the vacuum activated gas petcock. Went straight from gas tank to carb. While plugging the open vacuum hose and petcock. It will ...
Richard O'Connor's user avatar
2 votes
1 answer
6k views

Fuel gauge not working on 50cc moped

I recently bought a second hand 50cc moped, and the fuel gauge always reads empty. I assumed that it was the float sensor that was at fault, so I bought a new one. I connected the new sensor but the ...
Rocketman1105's user avatar
1 vote
1 answer
126 views

Increasing dead stroke of a hydraulic hand brake

This is a weird thing to want to do, but I want to know if there is a way to increase the dead stroke of a hydraulic handbrake for an electric moped. The dead stroke is the initial part of the lever ...
user172485's user avatar
3 votes
0 answers
761 views

VIP future champion gas moped won't stay running

Okay so my moped sits over night I go to start it and it turns over and starts for about 3 seconds and shuts off. Well it will not start again until I put raw fuel or starter fluid in breather. After ...
Jordan's user avatar
  • 61
3 votes
1 answer
5k views

VIP future champion gas moped (carb)

I have a moped talking, and on the carburetor there are usually two hoses, right? Because currently mine only has one coming from the carburetor, and the line is going to the gas tank. However, I do ...
Jordan's user avatar
  • 61
1 vote
0 answers
52 views

V2 engine white smoke and not running very good

I have a Gilera RCR moped with a V-twin engine. It's not very compact. I have run into a problem, it won't run when not moving and it has a lot of white smoke. Could it be an engine problem?
Kexkox's user avatar
  • 11
3 votes
1 answer
2k views

125cc moped light problems

I have a Direct Bikes 125cc Lynx moped. the front light is constantly going on and off (not all the time, just regularly and randomly). It's not noticeable in the day time to me, but now I ride home ...
lee harris's user avatar
5 votes
1 answer
173 views

Battery cuts on a moped when off the kick stand

I have done a valve adjustment on my 50 cc Pantere Fusion moped, and in the process my ground wire to my moped came completely off. I don't know if that's my problem or not though. I adjusted the ...
Robin Dustin Mcdonald's user avatar
2 votes
1 answer
13k views

Moped dies when trying to give gas after filling up gas tank

My moped has been running just fine lately but after I put gas in it immediately started choking off when I give it gas. The tank was pretty close to empty when I topped it off. Is that the reason ...
Michael Ball's user avatar
2 votes
1 answer
447 views

Moped bike motor problem carburetor

I have tried many technicians but none have solved my problem. I had problems in the past past, but one day my bike started to make a noise while opening the throttle when cold after about 50km/h ...
GorillaApe's user avatar
4 votes
2 answers
3k views

Motorcycle 125cc question about PISTON condition and battery

Last year I bought a 125cc bike, Modenas brand, most likely unknown to you. It is a moped. http://www.modenas.com.my/v2motorcycle.asp?id=70 It can go as fast as 110 km/h enough for the city, ...
GorillaApe's user avatar