Questions tagged [master-cylinder]

The tag has no usage guidance.

7 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
1answer
27 views

Stuck Clutch 1995 Alfa Romeo 916 S 2.0 l TS

I bought a Alfa Romeo 916 and knew I would have to do some work on it, including replacing the clutch. I bought a LuK clutch and replaced the clutch plate, pressure plate, and throwout bearing (...
1
vote
1answer
165 views

After changing brake lines the brakes are extremely soft. Bleeding doesnt help and theres no leak. No abs

I put new brake lines in the car, put the fluid into tank and started bleeding the system. The problem is the pedal goes hard after a few pumps but gradually loses pressure and its not getting any ...
1
vote
2answers
494 views

Brake pedal still soft

I have a 2007 Mazda 3. When I purchased it, it came with a soft brake pedal. I thought that the brakes needed bleeding, but after taking it in to get it bled, there was no difference and apparently it ...
1
vote
0answers
918 views

Did I ruin my master cylinder by putting vacuum pressure on the reservoir?

99 Saturn SC2 I was bleeding my brakes and accidentally let some air into the master cylinder because I didn't refill the reservoir. I was going to take the master cylinder out and bench bleed it but ...
0
votes
1answer
26 views

Why is my pedal vibrating and making a noise when I start to brake?

need some advice here. I have just gotten 2007 Mitsubishi Galant from relative with some braking problems. When I go to brake the PEDAL vibrates and make a loud noise. I have taken it too the shop a ...
0
votes
0answers
25 views

06 Toyota Corolla No Brakes

I have a 2006 Toyota Corolla with 132k miles. Just replaced the front brakes rotors and pads yesterday. Afterward, I manually pumped them up before starting the vehicle; however, upon starting my ...
0
votes
0answers
28 views

Replacing rear brake lines, is one enough or should I add two?

I am in the process of restoring a Mitsubishi GTO, who's brake lines have rusted. I'll be using NiCoper lines, replacing the Master Cylinder, removing the ABS modulator (also rusted and can't find a ...