Questions tagged [knock-sensor]
The knock-sensor tag has no usage guidance.
13
questions
1
vote
0
answers
39
views
Plug connector for Knock sensor Mazda 626 2.0L 1998
anybody know where is the connector location for knock sensor? For some reason looking for leaks i see this sensor without his connector but i dont know where is the other side for apply a repair.
...
- 11
1
vote
0
answers
184
views
Why is knock sensor tripping "check engine" light but only on warm-up (10 min/1 mi)
2011 Honda Pilot 4WD shows P0325 code but only until the car warms up (10 mins/1 mile). Reset with OBDII the code does NOT come back on. 87 octane gas from many stations in a 50 mile radius. Code does ...
- 11
1
vote
1
answer
1k
views
Can low fluid levels cause a knock sensor to become faulty?
I recently had one or both of the knock sensors in my '05 Toyota Highlander V6 go bad and I went to a mechanic to get both of them replaced. Some background: the check engine light came on and the ...
0
votes
0
answers
55
views
What does P0328 means?
Knock sensor High Input
The problem reappears even by clearing the error with the knock sensor unplugged… Is it something expected ?
Does it necessarily mean there’s a short circuit ? If not what ...
- 164
1
vote
0
answers
93
views
Where would the knock sensor be on a 1998 Dodge Grand Caravan SE 3.3 L 6 cylinder
So, my father owns a Dodge grand caravan, 1998, but it will not start. We have replaced the starter, the ignition switch, and even got a few new fuses. We have also replaced the battery, because the ...
- 111
0
votes
1
answer
74
views
What’s the part reference for the knocking sensor’s plug of my car?
I just changed the engine of my car, but a part from the new engine is missing as the old engine knocking sensor doesn’t fit inside the engine (despite both new and old engine being 190000J060 ...
- 164
1
vote
1
answer
12k
views
is it safe to unplug Knock Sensor for 1 day?
my car have jerking rpm (lagging rpm) NO ODB Error. i tired many ways but no luck. someone said it could be from knock sensor.
is it safe to unplug the knock sensor for a while to check my problem
...
- 55
3
votes
2
answers
2k
views
What will happen if the knock sensor fails?
I have understood that most recent cars have a knock sensor. This allows among other things greater timing advance due to detecting knock in case the fuel doesn't work well with a greatly advanced ...
- 14.5k
1
vote
1
answer
180
views
02 FORESTER VOLTAGE
Ran the codes on 02 Forester. We came up with P0328 Knock Sensor. I am putting on new fuel filter and plug wires. Does anyone know what voltage I should be pulling off of the knock sensor. Right ...
1
vote
1
answer
1k
views
Does no CEL after lugging engine indicate bad knock sensors?
My vehicle has a manual transmission, and occasionally I'll accidentally lug the engine briefly, when shifting into 2nd gear a little too soon after taking off. When I do this, I hear a sound (...
- 874
5
votes
1
answer
13k
views
2000 Lexus ES300 Knock Sensor code P0325 P0330
I have a Lexus ES300 that has was throwing the P0330 code. Being that I had limited time to chase the problem, I took a Saturday and removed both sensors, and the wiring harness that connects to the ...
- 171
5
votes
1
answer
3k
views
MIL comes on intermittently with Knock Sensor code
I have a 2000 Honda Civic iSR 1.6L D16Y8 MTX and the MIL comes on intermittently with a code for the knock sensor ( blinks out 23 when I short the code display pins ). The code goes away when the car ...
- 15.7k
2
votes
2
answers
2k
views
Oil Leaking in Back of Engine: Fresh oil under the oil filter cooler
I happened to noticed fresh oil on the backside of my engine ( 98 Mazda 626 GF 2L ), right under the oil filter cooler recently, right after starting up the vehicle after not driving it for a few ...
- 15.7k