Questions tagged [fuel-injectors]

A device that meters the proper amount of fuel into an engine cylinder. It is controller by the engine control computer.

Filter by
Sorted by
Tagged with
5
votes
3answers
20k views

RPM drop when coming to a stop in neutral, Civic 06

Let's say I'm getting off the freeway, I press the clutch, shift out of 5th to neutral. At that moment my Civic DX would usually drop to about 1000 rpm at idle. For the past month it drops too low, ...
2
votes
1answer
3k views

Injector leaking/seeping clean diesel over nut/body

I've got a 2005 Mazda 3 (ford inside), engine DLD-416/DV6/MZ-CD 1.6 Diesel, 109 PS. When I was blanking the EGR valve I saw some diesel surrounding the injector bases on all the four injectors. The ...
0
votes
1answer
203 views

Where is the injector circuit on a 2007 Toyota Yaris?

I have the PO201 error code which appears randomly every 30Km to 50 Km. The issue sounds possible as the car ran 2000Km with a damaged spark in cylinder 1 before repair. However, they are no circuits ...
1
vote
0answers
26 views

2012 Great Wall V200 Turbo Diesel injector coding

I have recently installed second hand injectors. I have software to reprogram the injectors into the ECU. However, it continues to come up with an error when I enter the new injector code. I have been ...
1
vote
1answer
34 views

Wrong injectors in 2 ports

I have a 2015 Cadillac Escalade luxury 4wd with 6.2 regular gas. I changed 2 injectors but by mistake the 2 i installed are high flow and the correct one should be low flow what is the worst that csn ...
2
votes
1answer
67 views

Why doesn't polarity matter for fuel injectors?

Why doesn't polarity matter for fuel injectors? If they are essentially a solenoid, then it seems it would matter; swapping polarity would change the direction the electromagnet pulls or pushes.
1
vote
2answers
247 views

Can fuel trim (LTFT) be too high or too low? Not using stock injectors

Application is a '97 Jeep Cherokee 4.0L straight-six I installed EV6 fuel injectors to replace the outdated EV1 injectors. The new ones are slightly higher flowing I think. old: 23.2 lb/hr @ 49 psi ...
1
vote
1answer
39 views

How to release fuel injectors from Volvo T5 engine?

How does one engage the release mechanism for the fuel injectors on a Volvo T5 engine? The spring clip doesn't seem to respond to any tugging so far and I don't want to break it. Here's a side ...
1
vote
0answers
58 views

Chevy Blazer 4.3 with p0303 error (cylinder 3 misfire) shortly after running medium-hot: now wonky idle, but smooth at high RPMs

I've got a 97 Chevy Blazer with the 4.3 and 281k miles. It might be of-note that a shop replaced my Lower Intake Manifold gasket about 18 months ago. At the very end of a long trip this weekend it ...
2
votes
2answers
500 views

Do petrol injectors need to be coded after replacing?

I have replaced petrol injectors on my Insignia A16XER with probably new one from China, but now car is not stable at idle and randomly increase revs. I am not sure if new one are defective or they ...
1
vote
2answers
1k views

Calculating fuel flow rate through obd || sensor not supporting 015E and 0110 commands

I have been working on a project where i want to calulate fuel flow rate using data from the obd2 sensor. The car on which i was testing didn't support the pid 015E which is for fuel flow rate. Then i ...
1
vote
0answers
19 views

How change methane injectors on Zafira 2004 CNG engine?

What is the process to change CNG injectors on a 2004 Zafira? What has to be disconnected?
2
votes
1answer
410 views

Diesel leak by fuel injector on Volvo V50 2007

So for a time now there has been diesel undeneath the fuel injectors. Could this be a simple o-ring seal gone rogue? Or a destroyed copper washer? There seems to be a little puddle of diesel by ...
1
vote
1answer
52 views

Does anyone know the style of connector used on Ford CFI throttle body injectors?

I am trying to find the part number on a connector for the injectors used on Ford's throttle body injection. This connector is on a Bosch injector made for Ford's CFI throttle body injection used on ...
1
vote
3answers
115 views

How do paired injectors work?

I'm currently in the process of searching for a cheap standalone ecu, but the main limitation of them is the fact that they have only 4 injector outputs. I have heard and read in the ecus ...
0
votes
0answers
24 views

Question about aircraft engine injector system

i was recently working alongside an aircraft mechanic on a turbocharged 6 cylinder fuel injected engine (a Lycoming TIO-540 if your curious) and the complaint from the customer was that it would ...
3
votes
2answers
99 views

Rebuilding EV1 Injectors

I recently bought the parts to rebuild EV1 (34.6# @ 43.5psi) injectors. The parts include the microfilter, flat support disk (for the injector end), and the supporting top cover (for the fuel rail end)...
7
votes
1answer
877 views

Volvo 2.0D engine “self-oscillates” after changing timing belt and adjusting fuel-injectors

I recently had the timing belt and water pump changed on my Volvo s40 (2006 2.0D diesel). The mechanic also cleaned and adjusted the injectors. After the service I noticed that att some rpms the ...
2
votes
0answers
60 views

1999 Chevy Suburban 5.7 - What is “Valid Reference Pulse”

Searching google for that exact text in quotes (what the scanner shows) yields basically no results. What does it refer to? For some context that lead to this question, I'm not getting my injectors ...
1
vote
0answers
354 views

Diesel engine struggling to start when cold

I have a 2.7D Ford AJD-V6/PSA DT17 diesel engine, on which I recently replaced 3 fuel injectors (all 3 of them were leaking). After the injectors were replaced, I now encounter the following problem: ...
2
votes
1answer
565 views

Volvo V50 felt like it was stalling while accelerating then engine stopped

So I bought a Volvo V50 about half a year ago and have been having some issues with it lately. The one problem that has been recurring is that often the engine has very little power. By little power ...
0
votes
1answer
66 views

Replacing diesel injectors

Two weeks ago, I purchased a 9 year old, second hand Ford Fiesta from a UK used car dealership. It's done 58,000 miles, has a full service history and has had a recent MOT. After the first week, one ...
4
votes
2answers
1k views

Why are my injectors different colors when they all have the same flow rate?

As can clearly be seen in the picture, the injectors on my 98 Mazda 626 2L GF are different colors: This is even mentioned in the official Workshop Service Manual: However, both according to the ...
1
vote
1answer
428 views

Are these fuel injectors leaking? How to fix?

please advise me if these 2 fuel injectors are leaking? If so, how to fix it? My car is Toyota Matrix 2010 (103,000km). (photos below) Thanks.
1
vote
0answers
46 views

Leaking injectors

How long would it take to damage a diesel motor where oil is diluted heavily with diesel,due to leaking injectors,engine made clunking sound and masses of black smoke poured from exhaust, service ...
3
votes
1answer
151 views

Diesel Injector Well full of Carbon

While looking over my friend's 08 Kia Carnival J3 2.9L Turbo Diesel, I noticed a strange huffing noise. After removing the decorative engine cover I discovered this: This injector well is filled ...
1
vote
0answers
77 views

Car Jump Started in wrong way

We switched the jumper cables when trying to jump start my Altezza 4 cylinder. Main fuse and other fuses were blown. I replaced all the damaged fuses and battery. When we eventually got the car to ...
3
votes
1answer
6k views

No voltage on injector lines following engine rebuild

I have a 2012 Ford Fiesta 1.4 L TDCi. It was starting normally but the engine had major mechanical problems so I have rebuilt it and put it back in without touching any electrical part. Now I'm ...
2
votes
1answer
10k views

Leaking fuel injector

If the body of a fuel injector is leaking (allegedly) and flooding a spark plug, there is any chance of fixing it cleaning the injectors or do I have to replace it 100%? How can I determine which ...
1
vote
0answers
56 views

Diesel van not starting in hot weather

I have a self-built motorhome, Renault Master, 2003, with about 100k and a G9U engine, which does not start when I park it in the sun in the hot weather. Part of this is due to the immobiliser ring ...
2
votes
0answers
21 views

Help maintenance & repair

06 Pontiac g6 will not start! I recently changed fuel pump. I am getting fuel to the fuel rail with pressure but fuel injectors are not opening. I can pour gas in the breather and it will start until ...
0
votes
1answer
213 views

Number of diesel injections per revolution

A modern TDI using a piezoelectric injector may have up to as much as five injections per power stroke as far as I've read. Given a four stroke, four cylinder TDI engine using injectors of that type, ...
1
vote
1answer
92 views

Running fuel injector outside the engine

I want to use an arduino I have lying around to make a fuel injectors tester/cleaner. It looks pretty simple, just connect the injector to a battery and the pin that goes to the ECU to a pulse ...
1
vote
1answer
33 views

How can I clean out bad fuel from my diesel engined VW Transporter?

How do I clean out bad fuel from my VW transporter TDI, and also clean the injectors. Can I do this myself? Edit: Dirty/water fuel not incorrect fuel. It’s dirty...
2
votes
0answers
93 views

USA vs Europe fuel injector differences?

This question is out of curiosity as I didn't find any specs or datasheets after plenty searching. What would the differences in the fuel injector be for Europe vs USA markets? I've compared ...
1
vote
0answers
232 views

High concentration fuel detergent effects on oil

I just did an oil change. I was planning on putting some fuel detergent in the tank and run in through before the oil change but forgot. Can I still put it in now without having negative effects on ...
2
votes
0answers
94 views

Car keeps breaking fuel injectors?

Ok so i'm having quiet a strange issues with one of my cars (08 X5 E70 4.8L V8) that may be worth discussing. It seems to keep "blowing" through injectors on only one bank. Suddenly i noticed CEL and ...
2
votes
2answers
1k views

Difference between fuel injectors and emissions standards

I have a 2004 Honda Accord EX Sedan with a 2.4L I-4 with California emissions and 250k miles on it. I desperately need to replace my fuel injectors but the price is steep! Can someone explain to me ...
6
votes
1answer
2k views

Do I have a fuel pressure or injector problem Part 2

This is a continuation of my previous fuel pressure / injector question. So the missing part for my fuel pressure gauge came in and I was able to do a few more tests. The first thing I think is that ...
1
vote
2answers
132 views

Bad fuel efficiency and suspected sticky / dirty injectors

The fuel efficiency on my 99 Nissan Almera 1.6L MTX has always been a bit below what I would expect, and the idle has gotten a bit rough lately, so I started poking around with a scope to see what I ...
0
votes
2answers
76 views

Is common-rail unreliable by nature?

After having a common-rail diesel car with low mileage who broke 4th injector, and one year after the 1st injector, I tend to be suspicious about the system. It features a deposit where fuel is at ...
1
vote
0answers
21 views

fuel injectors in a 2003 Cadillac Deville

What determines when your fuel injectors need cleaning? My car is emitting white smoke when pressing on the gas petal after stopping at a traffic light.
1
vote
0answers
27 views

alternative and compatibale injectors

A ford focus MK2 owner has been advised to replace the fuel injectors but the brand new OEM injectors are rare and expensive, so we are looking for compatible injectors that are used for another brand ...
2
votes
2answers
4k views

Best practice for replacing fuel injector o-ring?

Never worked on fuel side o a car so have a few concerns: What's best way to relieve fuel pressure? After swapping o-rings, does a lubricant need to be added to the o-ring to prevent damage when ...
1
vote
2answers
3k views

Wiring harness splicing - Soldering or Crimping Method

I need to rebuild the injector harness on an old vehicle using Y-splices on the wire to reduce cable usage/lengths (V12 engine). My question now is how to to the Y-splice on the wires. Soldering ...
2
votes
0answers
105 views

07 Camry Engine slow RPM and excessive fuel consumption reading

I have 2007 Camry manual made in Australia for Arabic gulf. The engine sometimes go to 500 rpm and suddenly stops. Or it also goes to 1500 rpm and doesn't return to 1000 rpm (which is the normal as ...
-1
votes
1answer
597 views

Mixing sea foam and gumout

I have clogged fuel injectors. I used gumout in my gas tank and it's not working. Can I mix sea foam in with it?
2
votes
0answers
46 views

Looking for Fuel Injectors for a Renault Clio Expression 1.5 cdi 2006 plate

I am looking at buying a set of fuel injectors for my car but not sure of what part number I can use. Equally can you buy a manual for car parts? Any help would be appreciated. Thanks in advance.
1
vote
1answer
64 views

Why have to concentrate on exhaust gas instead of inlet mixture in Indian Bikes for emission control [closed]

I am having Apache RTR 180 (carburetor version) . Having a question towards Bharat Stage (BS) (Emission Norms) against bikes. Recently went through BS specification. To achieve this, we are going ...
2
votes
1answer
116 views

How Carburetor/FI will handle fuel supply in high inclination angle

Lets consider, we are going in inclination. (ex:some where > x Degrees). At this time, how carburetor will pump the fuel into the cylinder. Since of high inclination, it is very difficult for the ...