Stack Exchange Network

Stack Exchange network consists of 175 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

Questions tagged [engine-mount]

Engine mount is a support that attaches the engine to the frame and dampens it's vibrations.

0
votes
0answers
17 views

Vehicle runs little bumpy after 120km/h speed./ Hyundai Sonata

I am having Hyundai Sonata 2012 model car. I am aware that 2 engine mounts need replacement in my car. When i drive above 120km/h speed, car runs little bumpy and giving a non smooth ride. Is it ...
1
vote
0answers
38 views

Car Jerk when switched to Drive and Engine Bangs (Knock) over bumps

I have Nissan Teana 230JM (J31) 2007 model. The issue i am facing is when I start the car in the morning then it takes some time to shift to Drive, So I have to switch it to 1st and then drive a ...
1
vote
2answers
110 views

Changed all engine\trans mounts, car vibrates even worse

I have 2002 BMW E46 330xi, it had some issues with vibration at idle (in drive or reverse). I have changed all 3 mounts plus new original nuts (2 for engine and 1 transmission mount). Tranny mount was ...
1
vote
0answers
114 views

Car shuddering, losing power

I have a VX Commodore 2000. A few times over the last few days it started to shudder as I reversed into a park and was about to conk out as I switched it off, then later as I drove home it started to ...
1
vote
0answers
39 views

Where to locate engine mounts on Nissan Note 2006 HR15 Engine?

My engine started slightly vibrating when the car is in drive and i am fully braked, and I believe it to be one of the engine mounts. Problem is, I don't know where the left engine mount is. I can ...
2
votes
2answers
915 views

Drove over a semi-large rock and now vehicle vibrates in Park - Goes away in Drive

So... I hit a rock pretty bad over the weekend :(. I was going about 100KM/h maybe less, and it was smaller then a basketball sized rock, but it did some damage and jolted me/vehicle. I immediately ...
0
votes
2answers
71 views

Clio MkII Engine Support

I am planning on replacing the clutch on my '04 16v 1.2L Clio Mk II this week. To do this I'm going to use an engine support beam to very slightly move the engine over to the side. Where does the ...
2
votes
0answers
237 views

2001 Toyota Rav4 O2 sensor change

When changing O2 sensor B1 S2 on 2001 rav4 do you have to loosen the engine mount to access sensor with o2 socket, or is there an easier way?
3
votes
3answers
887 views

Engine mount bolts not lining up

I have a '99 Subaru Legacy Outback, and I'm working on getting the engine (EJ25) back into the car after replacing the head gaskets. I got the four bolts that attach through the transmission ...
11
votes
2answers
4k views

Do I need to replace all engine mounts after one has failed?

I had the gearbox mount break in my Mk2 Citroen Saxo (one of three mounts holding the engine, gearbox etc up). The engine fell down due to the lack of mount, and the gearbox hit the floor (and cracked)...
2
votes
1answer
3k views

Is an engine mount a “covered component” under power-train warranty?

2012 Chrysler Town & Country with 69k miles. Vehicle jumps when putting into gear and from that diagnosed a failed engine mount. I bought this car used (CarMax) and took the claim to my warranty ...
5
votes
2answers
177 views

Noises & “Feedback” while cornering

I recently took possession of a 2004 Volvo S60. I knew it had a welded engine mount, but that it was in otherwise good working order. This has been the case until a couple of weeks ago when I noticed ...
6
votes
1answer
1k views

Car bounces back and forth after shifting

I've been having this issue for a while on my 1999 Volvo V40 T4 manual. Whenever I shift and release the clutch quickly, the car often does a nasty bounce. Let me try to describe it with much detail ...
4
votes
2answers
931 views

Safe Way to Remove Engine Mount Support?

I'm working on a 98 Mazda 626 2L and I'd like to change the transaxle oil filter. However, a number of the pan bolts are blocked by a beam which has an engine / transmission mount sitting on it ( see ...
7
votes
3answers
13k views

How important is it to replace engine torque mount? (have pic)

I just bought a 2007 Buick Lucerne. The rubber in the engine torque mount has separated into two pieces. How important is it to replace the mount? If I do decide to replace it, is the job as ...