Questions tagged [clutch]

The clutch disengages the engine from the gearbox in a manual-transmission car, enabling the driver to change gear.

Filter by
Sorted by
Tagged with
1
vote
1answer
162 views

Astra turbo sri clutch

I have just picked my car up from garage after 6 bearings and end plate changed on my Astra Sri turbo gearbox, now my clutch is slipping badly and I have an oil leak that wasn't there before
0
votes
2answers
81 views

Clio MkII Engine Support

I am planning on replacing the clutch on my '04 16v 1.2L Clio Mk II this week. To do this I'm going to use an engine support beam to very slightly move the engine over to the side. Where does the ...
3
votes
1answer
134 views

On a 2007 Ford Galaxy Clutch Replacement

On a 2007 Diesel Ford Galaxy, Do you need to replace the dual mass flywheel also along with the clutch. Thank You
2
votes
2answers
3k views

Motorcycle rear wheel stuck after being unused for a few years

I'm trying to get my old bike up and running again after a few years of waiting, mostly outside, covered but still subject to all kinds of weather. When i parked it it was fully functional, but now, ...
1
vote
0answers
1k views

Squeak noise coming from clutch release mechanism when clutch disengaged

I need help diagnosing and fixing a sound coming from my 2007 Subaru Outback, 2.5L engine, 5 speed manual transmission. It is making a rhythmic squeak/chirping sound at idle, almost sounds like a ...
2
votes
1answer
691 views

Bike shaking while in half clutch

This is a UM Renegade Commando. The whole bike starts shaking when I leave the clutch, and I can't drive my vehicle in half-clutch. This problem usually occurs after the clutch is continuously used ...
-1
votes
1answer
77 views

Is it a bad clutch or something else? Help!

I have 2006 infiniti g35 coupe sports package, I recently bought the car and all of a sudden the clutch starts reving very high. I'm talking in the morning it was fine but in the afternoon of the same ...
2
votes
1answer
4k views

Soft clutch on Ford Ranger following brake cylinder, clutch cylinder replacement

I need help with my Ford Ranger diesel 2.2 L clutch. It had a problem with the brake cylinder which I replaced. Then the clutch became soft and had little to no resistance, which becomes worse on ...
2
votes
1answer
218 views

Weird symptoms from the clutch

I drive Vauxhall Insignia diesel, 2.0. Never had any problems with a clutch, and yesterday it developed 3 faults! There is a grinding noise when the clutch pedal is pressed, not very loud. But ...
1
vote
1answer
3k views

Can't shift into any gear even when engine is off

For about a week there have been times that I've had trouble shifting into and out of gears on my 2010 Dodge Caliber. Some days it didn't do it at all, but others I had to put the car in and out of ...
1
vote
0answers
7 views

clutch,transfercase,manual,gears? Help 1994 toyota 4 runner [duplicate]

My 1994 4 runner will go into gear, but will not move. It does not jerk or stop running when i let clutch out while in gear? Is it the clutch, trance-fer case or something else? And if it is trance ...
1
vote
0answers
619 views

Clutch pedal won't go to the floor to engage neutral safety switch

This is a 1993 K1500 Sierra 4x4. I just replaced the clutch master and slave cylinders and bled the line. The clutch has pressure but it won't go all the way down to engage the neutral safety switch....
2
votes
1answer
3k views

Vehicle shaking after a new clutch job

I just recently replaced the clutch on my 2007 Subaru Impreza. I did the clutch myself and had the flywheel resurfaced at a shop. The car shakes when i accelerate from park to first until I release ...
1
vote
1answer
297 views

2003 Honda Civic Si - Do I need to drop my trans to replace the pilot bushing?

So I've been hearing this whining noise with the clutch engaged in neutral, as well as in gear around 3k rpm. After doing some research I am convinced that it's the pilot bushing. I saw a few guides ...
-1
votes
1answer
241 views

Car Clutch issue after repair Vauxhall Zafira 2007

I replaced the gearbox cable at mechanic and after that the clutch box is not working properly. All the gears are very loose and the first gear sometimes works as a reverse gear but the reverse gear ...
5
votes
1answer
116 views

clutch installation

I am installing a new clutch in a 1999 Miata. When putting the tranny back in, I can get it in very easily, but it won't go all the way, it only lacks about half an inch. I can get bolts started but I"...
1
vote
1answer
246 views

Ford Fiesta MK6 deep moan with release of accelerator

While driving my Fiesta on the motorway I noticed that at around 3000rpm/70mph that if I release my foot off of the accelerator completely (I just let the current momentum propel me forward) the ...
1
vote
0answers
89 views

Why won't my Mustang move in 1st, 2nd, 3rd gear after clutch change?

My mustang will not move in first or second or 3rd gear but will in 4th gear. I really need some advice regarding the issue. It is rattling when the pedal isn't engaged. I recently paid for a new ...
2
votes
0answers
19 views

Mini Cooper base

The shift cable bushing broke. I replaced it. I had to replace the slave cylinder and master cylinder. I have bled the clutch. I have a good clutch pedal with the car running and I can put it in ...
0
votes
1answer
2k views

Burnt clutch on new vehicle

I have a brand new Ford Transit, it has only 2000 miles, the other day on the motorway the car wouldn't go into gear properly in a traffic jam. I could only use 3rd and 4th gear. I managed to get the ...
2
votes
2answers
4k views

Motorcycle missing Neutral when it's on

I'm new in this (Motorcycling). I've bought a motorcycle (http://italika.mx/modelos/chopper/TC200/) I'm in Mexico. The issue is, that whenever the bike is off, I can shift really comfortable to N; ...
3
votes
1answer
314 views

Clutch Adjustment

I have a 2004 Suzuki Wagon R. I only have to dip the clutch a fraction to select a gear, which would indicate the clutch pedal is not coming off properly. The pedal is stiff, with no play in it. And ...
3
votes
0answers
92 views

Car Hissing on Neutral After Checking Spark Plug

So last night, two days after examining one spark plug and putting it back in, I noticed a hissing sound from the front of the car. This hissing goes away completely when I press the clutch pedal in. ...
1
vote
0answers
73 views

Is this transmission busted

This is a lancer evolution X MR with the Dual clutch TC-SST transmission: https://en.wikipedia.org/wiki/Twin_Clutch_SST The car will not move when in gear, the engine will rev but the car will not ...
3
votes
1answer
401 views

Car Jerks When Not Accelerating

So, I just recently mounted snow tires on my car (or rather, paid someone else to do it), and on my way home I noticed that whenever I take my foot off the gas pedal the car jerks forwards and ...
2
votes
2answers
106 views

Fiat Stilo 1.6 2003 - grinding when shifting

I have a Stilo, and I need to force it(most of the time) to get in to gear 1, and is grinding in rest of them ,but always I got different resistance from the stick. Also in gear 1 is making a funny ...
1
vote
1answer
143 views

are there any modern cars that use a mechanical clutch?

I know that it's still widely used in motorcycles but what about cars? I thought it would be easy to find out which manufacturers still produce vehicles with a cable actuated clutch but I guess I was ...
3
votes
1answer
535 views

After changing MTF, my truck grinds into every gear. Is this a symptom of a bad transmission? Or just a bad clutch?

After changing out the transmission fluid on my 1997 Nissan D21 4x4, the transmission started shifting really rough. My first piece of troubleshooting was to adjust the clutch pedal as specified in ...
2
votes
2answers
3k views

Clutch Fault, Ford Fiesta ST 16 Plate

I need some advice please regarding my Ford Fiesta ST-3 2016. I had a problem about 3 months ago, I was driving and the clutch randomly slipped causing the revs to shoot up. It was on a Saturday so ...
1
vote
2answers
672 views

Ducati Monster shifting gears almost impossible

I bought a brand new Ducati Monster 797 ABS. If I just turn the key the gears are shifting very easy and no problem finding neutral. Once the engine is running it is just about impossible to shift up ...
1
vote
2answers
388 views

2004 Toyota Corolla - Sudden loss of clutch engagement

I was driving to work this morning when all of the sudden at 30mph the clutch disengaged. I had just shifted in to 3rd when it happened and initially i thought i hadn't got it in gear properly, but ...
3
votes
1answer
534 views

Disengaging gear when braking/Coasting

I've recently found an eco mode on my car that is now showing tips to drive more economically. It's recently flagged up a tip saying 'don't disengage clutch above 1300rpm' which I believe it is ...
2
votes
1answer
2k views

Infrequently sticking clutch in 08 VW GTI

I have owned my 2008 GTI MKV FSI for the past 4 years. For the first ~8k miles (bought at 42k), everything behaved as expected and performed nicely. At a certain point around 50k, I noticed that the ...
1
vote
1answer
117 views

Clutch biting at high revs when pressed down

I have a 2004 Renaultsport Clio 182. I was toying with it yesterday and had the car in first gear, clutch flat to the floor, and I revved the car. At around 6000 rpm I felt the clutch bite and the car ...
3
votes
1answer
83 views

Gears wont select on my mitsubishi space star

I have a Mitsubishi space star 1834 cc petrol 2004 The mechanic said circlip on the the clutch thrust came out which resulted in not being able to select a gear and drive away The mechanic put the ...
1
vote
0answers
29 views

changed dmf too solid clutch in astra 1.7cdti

i have replaced 1.7cdti engine for another 1.7cdti the new 1 came with dual mass so put our solid 1 on now it wont clear gears but will clutch bite if put into gear befre starting there is no air in ...
2
votes
1answer
136 views

rear wheel spin on motorcycle

With my bike on a paddok stand and turned on,I know the rear wheel spins in neutral but when I put it in gear and pull the clutch lever in it still continues to spin.Now the question is I can stop the ...
1
vote
0answers
345 views

Can't depress clutch

Bought my first rexy back in december, it's a 2012 WRX. Couple of days ago the clutch pedal wouldn't spring back up. I've googled around and some say it could be the clutch master or slave cylinder. ...
1
vote
1answer
50 views

What's wrong with my car?

I need Some opinions on 1992 prelude i have. Its the f22a1 5 speed . But I was coming home other day and going into 3rd and it made a odd banging noise then lost the gears. It wouldn't go into any ...
1
vote
2answers
2k views

Super 95 E10 vs Super 98?

Can i use Petrol: Super 95 E10 in my car? I basically use Super 98 on my car but the price is very expensive now 1.50 Euro cent. Where as Super 95 E10 is 1.20 Euro cent. My car manual says i can use ...
1
vote
3answers
12k views

I have 5th gear issue , can i drive in 4th gear at 100km to 115km?

My car scares me while changing gear from 4th to 5th gear because it goes to 3rd gear. As a result on highways i get scared to change to 5th gear. Can i drive my car in 4th gear at speed range ...
4
votes
3answers
1k views

4th gear to 5th gear puts to 3rd gear often?

R, 1, 2, 3, 4 works great. But when i am in highway driving 90km to 120km and trying to switch to 5th gear. I have a strange problems. When Engine is running live: - from 4th dragging straight to 5th ...
2
votes
1answer
94 views

2014 Kawasaki Ninja EX300A Clutch

So I'm getting to the point of having to replace my clutch components (planning on just the standard "kit" parts, friction & clutch plates and new springs), and I haven't been able to find what ...
2
votes
2answers
1k views

Motorcycle low top speed

I recently took my dad's unused pulsar 180cc and gave it an overhaul.I replaced the carburettor,airfilter,spark plugs and clutch plates.But the bike doesn't run like other motorcycles of the same ...
1
vote
2answers
33k views

Burning smell after stalling in hill start

I am driving a manual car and I usually have no issues with hill starts. Today, however, after pulling my e-brake on on a hill and then engaging 1st gear. My car would not pull forward from ...
0
votes
2answers
5k views

Why does my clutch pedal squeak

My clutch pedal squeaks on its way in and out. I was hoping it was the pedal itself, but when I got under the car it sounded like it's coming from under the engine, where I presume the clutch is ...
0
votes
1answer
427 views

When clutch full disengaged and engine on high revs, feeling of friction in clutch

Today I was driving my KIA cee'd 1.0 T-GDI. I was standing on a traffic light and the street was empty. So I decided to have a little fun with my car and accelerate as fast as I can. The car was fully ...
3
votes
2answers
424 views

I'm going to replace my manual transmission. What else should I replace at the same time?

Vehicle 2006 Civic Si 115k miles 6-speed manual transmission (original, including clutch) Question It's getting harder to shift between gears. When upshifting, I need to wait a while for revs to ...
1
vote
1answer
1k views

Clutch pedal became “springy” after installing new clutch

I've had clutch replaced on an old Suzuki Wagon R+ to a new aftermarket one. While it fixed the problems of changing gears I had, however, the clutch pedal is very stiff now. When pressing about ...
3
votes
1answer
474 views

Optimal clutch engagement speed at wide open throttle

While pretending I was a race car driver this morning, a question occurred to me: When you engage the clutch quickly while up-shifting at wide open throttle (i.e. accelerating as fast as possible and ...