Questions tagged [clutch-plate]

A device used in vehicles to transfer energy from an electric or internal combustion engine from the power unit to the transmission. Specifically the clutch plate is the part of the clutch assembly which clamps the friction disk to the flywheel.

8 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3 votes
0 answers
50 views

How many fair labour hours to change a clutck kit of a 2L GWM Steed 4x4

How many fair labour hours required ti change a clutch kit of a 2L GWM Steed 4x4 please. Thank you.
user avatar
2 votes
2 answers
2k views

Motorcycle clutch with grinding sound

I have a Suzuki Gixxer 155 2015 model. After going to a shop for vulcanizing my rear tubeless tire, it felt like I was carrying a very heavy load. It was a very heavy traffic in my area so I used ...
user avatar
  • 21
2 votes
0 answers
603 views

Mystery-2008 Scion xB sticks in gear

So my wife has a 2008 Scion xB with a manual transmission. We've been having a problem that comes and goes with it, and is difficult to get to the bottom of. When we're driving the vehicle, it ...
user avatar
  • 21
1 vote
0 answers
58 views

Clutch replacement: How to check if Diaphragm Spring should be replaced?

In the near future I will replace the clutch friction plates for my motorcycle (1984 Yamaha FJ1100) and most likely also the steel plates (the bike's done 80k km so I think they are due for ...
user avatar
1 vote
0 answers
27 views

2010 Mitsubishi sent up with the car just idling. The compressor isn't working because belt isn't turning & sparks & smokes a little when cranked

The compressor isn't working because the belt isn't turning causing it to spark and smoke a little bit when I crank it. That's without the AC or heat being on. Also, when I drive it it makes the loud ...
user avatar
1 vote
0 answers
84 views

Motorcycle clutch longevity: Race v.s. Road

So I realize this question may be on the line of too broad, but I think the answer(s) could be of future use to others as well, so I’m asking. Bike: 2014 Kawasaki EX300A (296 cc I think) At 9,000 ...
user avatar
0 votes
0 answers
34 views

Why does the clutch of my bike starts slipping?

I own a bajaj pulser rs200 which is a 200cc bike. I use is daily to go to work and back for about 20km. I usually ride fast and i am always above 7000rpm. I always release clutch rapidly after ...
user avatar
0 votes
0 answers
47 views

Can't do adjustment in clutch cable in motorcycle

I installed a new clutch cable on my bike but after installation, its adjustment bolt was tighten at last. I don't understand why it is like that I can't adjust anymore in new cable. Please suggest me ...
user avatar