Questions tagged [brakes]

Brake systems on vehicles are typically driven by either pneumatic or hydraulic systems that multiply the force applied by an operator to slow a vehicles rate of speed through the use of friction.

Filter by
Sorted by
Tagged with
0
votes
1answer
22 views

Squeaking After Rotor/Pad Replacement?

Anyone know what could be causing the squeaking in this clip? I recently had my rotors and brake pads replaced. It appears to only be coming from the right rear wheel. It doesn’t go away even after ...
1
vote
2answers
65 views

Brake disc corrosion - do they really need to be replaced?

I've been told by an authorised Mercedes service engineer that all 4 discs and all 4 pads need changing on my Mercedes GLC 43. It's just over 2 years old with 30k miles on the clock, so I am pretty ...
0
votes
0answers
41 views

No brake pressure after Starting the car

I have a 2003 vw golf and i have a brake problem. After i have bleed the brakes and feel that they are working I jump in my cart to start it bu as soon as I do so it just looses all brakes and ive ...
0
votes
0answers
17 views

Truck will not budge 06 f150

So this week end I changed my brakes. Flex lines, caliper, rotors and pads in the front and rotors and pads in the back. I greased all moving parts where they should be, gravity bled my brakes making ...
0
votes
1answer
40 views

Replacing section of brake line

I'm performing some repairs on a Kia Rio MkII, after experiencing some brake issues I'm in the middle of rebuilding the rear right brake caliper and replacing the brake hose. I was hoping to be able ...
0
votes
1answer
40 views

Handbrake was on while taking reverse [duplicate]

Bought a new tata nexon (automatic) and while trying to take car in reverse from a downward place handbrake was on by mistake, startes noticing burning rubber smell and smoke from bonnet. Immediately ...
0
votes
2answers
66 views

Car Insurance and Collision [closed]

Someone was driving my vehicle and the ABS lights came on and suddenly the brakes were barely working. They are a family member but I have a car insurance policy for my car only and they have a car ...
1
vote
1answer
48 views

How can I replace this brake line?

This picture shows you the brake line. It's on a 2002 Ford Escape. I changed the shoes a few days ago and I think I yanked on it or something. Anyways today while driving all of a sudden the brake ...
0
votes
1answer
33 views

Brake shoes rubbing on drum

I recently installed new brake shoes on my car's rear drum brakes. Although the brakes are working ok I noticed the shoes are rubbing slightly on one wheel. It's only rubbing on one spot and I can ...
0
votes
2answers
53 views

Car unstable after a disc and pads change?

I replaced a rear rotor and pads and also just pads on other side. I didn't replace rotor on other side as first caliper carrier had to be cut off and I didn't have time to do same of other side hence ...
0
votes
2answers
56 views

How to adjust shoe clearance after installing new brake shoes?

I just finished installing new brake shoes on a 1997 Y10 Nissan Wingroad. The image below is from the service manual and shows the page with installation instructions (starting about halfway down the ...
0
votes
2answers
66 views

How to clean grease from drum brake shoe lining?

I'm replacing the brake shoes on the rear drum brakes of a 1997 Y10 Nissan Wingroad. When fitting the new brake shoes the shoe lining became contaminated with grease from my hands. What's the best way ...
0
votes
1answer
68 views

Can I put smaller brake discs on my car than were on it?

Could I put 256mm discs on where previously they had 270mm discs. Both sets apparently fit my car according to data info sites?
0
votes
0answers
28 views

Snapped brake caliper bolts - were they damaged before I removed them? (And why?)

Doing front rotors, pads, and wheel bearings on my Subaru recently I had all four of the 17 mm bolts that attach the caliper brackets to the 'knuckles' break off. These snapped off cleanly and felt ...
1
vote
1answer
38 views

Do brake disc diameter get thinner?

Real weird problem here. If I search car part sites by REG for brake discs it tells me I need 256mm discs. Also eBay tells me this. Now the dealer tells me I need 260mm discs which some eBay sellers ...
0
votes
1answer
48 views

Does a diameter of a brake line affect braking pressure

I am currently building a brake system for a vehicle ground up and I know that the diameter of the master cylinder would affect the braking force proportionally to the area of the master cylinder. But ...
0
votes
0answers
23 views

do modern OEM brake pads contain asbestos? [duplicate]

While changing the oil today in a friend's shop (USA), someone grinded a OEM Ford brake pad that seems a few years old. The brake pad model number is Ford GA 8135 FG, and I was about 20 feet away. He ...
0
votes
0answers
26 views

What could be the cause of intermittent car brake grinding noise at slower speeds?

I recently bought an used rental Hyundai Elantra 2019 SEL and it has 40K miles on it. After driving the car for about a month, I have been hearing unpleasant sound coming from the brakes. The sound ...
1
vote
0answers
102 views

Constant knocking noise, rear drivers side

Long time user, first time poster! I know "knocking noises" are prevalent in many questions but I've not quite found the answer to this one... Bit of history, it's 2002 Civic Type R. Over ...
0
votes
2answers
49 views

Squeaking noise when braking once per wheel rotation

I have a Hyundai Tucson 2016, and when I'm breaking, I hear some sort of a squeak sound that comes from the front left side of the car. It seems to occur once every full wheel rotation. So the faster ...
0
votes
0answers
32 views

Car brake pedal pushes against my foot

I have a 5 year-old Toyota Rav 4. There seems to be a problem with the brakes. When I press the brake pedal, it pushes my feet back in intervals, thus makes my car braking distance longer than usual. ...
0
votes
0answers
15 views

2006 f250 SD Hard brake pedal when motor is off pedal sinks to the floor when started but comes back up when foot is moved [duplicate]

The truck has new brakes all around, brake sys was bleed by service manual. When truck is not running a good solid pedal goes down about 1 to 1 1/2 inch and stays there.(good pedal) Start the eng and ...
3
votes
1answer
58 views

Are these unmarked bolts OK for brake calipers?

I'm replacing some broken bolts in my front Subaru brakes. Specifically these are the 17mm bolts which attach the caliper bracket to the hub / knuckle assembly. The calipers separately attach to those ...
1
vote
1answer
107 views

How to remove broken bolt stubs from brake caliper bracket?

Here's the bracket from the passenger (right) side front brakes on my Subaru Impreza. Both (17mm) bolt heads snapped off when I tried to remove them using a socket using manual pressure only, no ...
0
votes
1answer
32 views

Do I Adjust the handbrake cable before I fit and adjust new brake shoes Nissan Note 2006

2006 Nissan note handbrake adjustment, do I unadjust the handbrake before fitting new brake shoes
1
vote
2answers
90 views

Dual brake calipers with one brake line?

A comment at the end of this ChrisFix video (at about 14:42): https://youtu.be/gjqeFEyaUxc?t=882 raised my eyebrows a tiny bit. Chris says that you can run two brake calipers (two calipers on each of ...
1
vote
1answer
84 views

Sudden Hard Brake Pedal

I was driving home today when the brake pedal suddenly got stiffen, if i apply the brake suddenly the brake pedal is so hard that it wont go down enough to hold. I checked and find out my brake fluid ...
24
votes
2answers
4k views

Why do the brakes “freeze” the suspension?

Last week I was driving a motorcycle. When I stopped at a traffic light I noticed the rear suspension dropped a little when I released the rear brake. Later I noticed my car did the same thing. When ...
4
votes
2answers
405 views

ABS Warning and Brake Calipers - Long Post

Edited: I received photos from the shop and I’m wondering if this changes any opinions. I have a 2016 Chevy Malibu LT 1.5L in Florida that we’ve had for going on 1.5 years. I’m sorry this is so ...
1
vote
1answer
39 views

Front right wheel making low pitch screeching when driving

Whenever I reverse at low speed at full lock the front right wheel makes a low pitch screech. The sounds is now starting to occur when driving forward. Tapping the break gets rid of the noise ...
0
votes
0answers
16 views

2007 Silverado 1500 Brake Problem

2007 Chevrolet Silverado 1500 V8 5.3 LT Air Leak in the Booster , Pedal was soft at this point before the repair but still had some braking power. Since we could hear the air escaping from it, we ...
0
votes
0answers
20 views

Intermittent juddering sensation felt through the pedal on moderate braking

Sometimes, but not always, when braking fairly gently (e.g. approaching a red traffic light) I feel a juddering or pulsing vibration sensation through the pedal. As I slow, the frequency slows, and I ...
0
votes
0answers
30 views

When changing handbrake cables, do rear wheels need to be removed?

Civic coupe vti 1999. Handbrake is loose. I think this mean one or both cables need to be changed. When doing so, do rear wheels need to be removed or can you just get under the car, remove and add ...
0
votes
2answers
115 views

Why does the rear suspension compress when the e brake is applied, but not when the foot brakes are replied?

The title explains the question fairly well. The rear suspension also dips when power is applied (in the case of launch control). Does this phenomenon occur on independent suspensions, and why exactly ...
0
votes
0answers
34 views

2002 GMC Sierra Brakes spongy

I have a 2002 Gmc sierra SLT that I just picked up a few months ago. The issue is that the brakes are awful, and they appear to be an issue the previous owners were chasing down too, all calipers, ...
0
votes
2answers
114 views

Why don't we have jake brakes on cars?

While Jake brakes are common on large trucks, we don't have them on cars. Why is that? They allow extra braking power, they don't upset the balance of the vehicle and they reduce wear on brakes. I ...
0
votes
0answers
25 views

Thudding when slowing to brake

2014 Jeep Compass Limited. Had brake pads, rotors, and calipers replaced ~6 months ago @dealer (had no issues, but @oil change appt dealer recommended). Have driven the car maybe 1,000 miles in 6 ...
1
vote
1answer
57 views

my driver side front rim was steaming hot after driving 130km/h through the mountains and severe braking for a couple hours

my driver side front rim was steaming hot after driving 110 - 130km/h through the mountains and severe braking (from going downhill) for a couple hours, while i did not notice brake locking when ...
0
votes
1answer
39 views

Should a rotor be replaced if its surface is coarse or rough?

When I was in the store to replace tires, the mechanic said I should replace two rotors. The back rotors are smooth when I touch them but both front rotors are very coarse, like lines drawn on to them ...
0
votes
1answer
48 views

What are the limiting factors for braking performances?

In a car with disc brakes, the performances (how long it takes to brake, how many braking cycles can be performed without overheating, brake power before locking the tires, and so on) depend basically ...
-1
votes
1answer
43 views

Bf falcon trying to skid

i tried doing a skid and burnout i put my foot all the way down on the brake and accelerator with traction control off tried multiple times nothing happen expect when i went to a dirt road it worked ...
2
votes
1answer
113 views

Can silver antiseize affect ABS sensors?

I recently did a full brake pad and rotor job on my Kia Sorento 2011 and it turned out well. No real issues. However I am now getting a few warning lights on my car that is indicating an issue with ...
0
votes
0answers
35 views

Toyota Rush creaking/groaning sound when start moving after stopping

First of all, some background info: I got my car -- brand new -- in February 2020. But due to some document mishaps, I didn't actually take it out for a ride until March 2020. So it just sat there in ...
0
votes
1answer
48 views

Grinding noise from brakes

Lancer 2005 es non-abs I have this problem of brakes grinding from the driver side wheel. All parts are new. Wheel bearing, brake pad clips. Brake pad, rotor, tyres. Still grinding noise. The noise ...
1
vote
0answers
32 views

Motorbike brake pedal not working

I’ve just replaced the brake fluid on my Mash Black Seven 125. The front brake works well off the leaver but the pedal does nothing. It still has pressure and does not feel soft but doesn’t make ...
0
votes
0answers
36 views

Is is normal for brakes to lock if braking too hard while wearing in new brake pads. 2000 Holden Frontera UES V6

3 days ago I had my brake pads,rotors,calipers and disc replaced. The mechanic told me to take it easy on the brakes while they are in wearing stage. Today I was going about 40km and Im not sure if i ...
0
votes
1answer
42 views

Identifying brake related noise when slowly letting it off

I got a brand new car for the first time. It's an automatic transmission. So far so good except for some noises I'm hearing. When putting the car into reverse, slowly letting go of the brakes makes ...
0
votes
0answers
36 views

Can I shift the AT gear while on handbrake without using the brake pedal?

Probably I will seem a bit silly, but still. I have Toyota Corolla 2006 with automatic transmission. Today, after the ride, I was curious to see how the motor behaves on different gears. Car was ...
0
votes
1answer
50 views

What motorcycle has brake rotor with bolts pattern of 4x55mm?

I just bought a rear rim for motorcycle but it doesn't have brake rotor. Pattern of mounting bolts is 4 holes (in square) and spacing between holes is 55/56mm (maybe 55.5mm) - square base. And (square)...
0
votes
1answer
34 views

Why is my pedal vibrating and making a noise when I start to brake?

need some advice here. I have just gotten 2007 Mitsubishi Galant from relative with some braking problems. When I go to brake the PEDAL vibrates and make a loud noise. I have taken it too the shop a ...

1
2 3 4 5
21