Questions tagged [brake-pad]

Cartridge of friction material that is contained within a brake caliper.

Filter by
Sorted by
Tagged with
7
votes
3answers
3k views

Rotor Replaced and MY Car is only 3 years old

I went to pep boys because i heard squealing and my pads were worn down. he also told me that i needed to replace my rotors so not knowing anything i did but i asked them tog ive them to me so i could ...
6
votes
2answers
32k views

How much disc brake drag is acceptable?

As far as I know brake pads are supposed to maintain slight contact with the rotor at all times. As usually the only thing pushing the piston back after braking is flex of the square cut seal around ...
6
votes
2answers
656 views

Brake pad doesn't fully contact disc

My brake pads don't appear to fully contact the disc. They extend past the disc. Is this normal? Did I get the wrong size brake pads? I don't recall ever having this problem before. I am also ...
5
votes
2answers
14k views

How much distance would 1mm off front brakes translate into?

I am planning to replace my front brake pads within a month. I was told that if my brake wear sensor trips, I will need to buy new sensors as they will get destroyed. So I am trying to save my brake ...
5
votes
3answers
4k views

Do I need to replace just my one rusted rear rotor, or do I need to replace both rear rotors?

I have one rear rotor that is partially rusted on the braking surface and the rust won't go away. I tried scraping down the surface to even it out, and then the entire surface looked rusted. I had ...
4
votes
3answers
291 views

In general, are there signficant differences between OEM and non-OEM brake parts?

The cost of OEM parts for some cars are just completely crazy, compared to the cost of non OEM, third party parts for the same cars. That said, the quality of the cars must be at least somewhat ...
4
votes
2answers
253 views

Sticking brake pad on 2012 Kia Rio 1.4L

My Kia Rio's brake pads made it to the indicator. Upon checking the pads it seemed that the pad situated against the piston is much more worn than the opposing pad. I removed the brake pads and ...
4
votes
1answer
1k views

Does brake fluid require topping-up as brake pads wear out?

The other day I was watching a video of a guy changing brake pads, and the first thing he suggested was opening the brake fluid container to remove some fluid with a syringe. This is to avoid ...
4
votes
0answers
289 views

Pulsating brakes and vibrating car after pad replacement (that later went away), should I continue driving?

I have changed brakes at local auto garage. On first drive around the town and local road brakes heated up to almost red smoke was coming and I was worried that tires will get on fire, you could hear ...
3
votes
1answer
955 views

Does 14' Audi S4 (B8.5) have rear brake pad wear sensors?

I am shopping for new rear brake pads for my 14' Audi s4 b8.5 and cannot find any information on the rear brake pad wear sensors. To my knowledge, the front ones had these sensors and I had to ...
3
votes
2answers
7k views

Grinding noise when braking after fitting new pads and discs

Just fitted my own pads and discs to both front wheels for the first time. Driver's side is fine but passenger's side makes a slight grinding noise when I brake. The caliper on the passenger side was ...
3
votes
1answer
66 views

Front Brake Pads problem

I replaced a front rotor and caliper on my 1994 Oldsmobile but not the pads, I have rust spots on it and even after I drive it the spots of rust are still there. Does this mean that the pads are not ...
2
votes
2answers
325 views

For the '03 Audi A8 3.7 V8, can you retract the rear calipers without the need for dealer tools/software?

As far as I can see, if I understand it correctly, you need special equipment to replace the rear pads on many Audi's. Otherwise you won't be able to retract the rear calipers. Is this also true for ...
2
votes
3answers
383 views

Do I have to scrape the brake pads?

I own a Dodge Nitro and I have replaced all the brake pads. Now I have just bought four(4) new rotors (slotted). Do I have scrape the brake pads after I replace the rotors because the rotors are ...
2
votes
1answer
72 views

Can I change the brake pads without changing brake disc for the front tyres?

I drive Honda Jazz 2010 model. My brake discs for the rear tyres have experienced some corrosion and I intend to change the brake discs together with brake pads for the rear tyres. My brake discs ...
1
vote
2answers
355 views

Install 2 different brands of brake pads on front wheels

My truck (92 Ford Ranger, rwd) has suffered from brake dust on the front wheels over the past few brake pad replacements. I don't remember it being this bad with the brake pads which were on the front ...
1
vote
2answers
49 views

When should I replace a 2016 Subaru Forester brake pads?

Last time I put my 2016 Forester to a regular service, I was told I need to replace the rear pads and rotors, and to revisit the front pads as they have some 5mm left on them. When do you replace the ...
1
vote
3answers
65 views

Do I have to replace brake discs as well as pads?

I'm on my second Mercedes (CLK then C class). I gather that due to the design, where the pads grip slightly inside the edge of the disc, the discs will always become lipped. Whenever the pads have ...
1
vote
1answer
705 views

Brake pads aren't fitting into the caliper slots of my civic?

I brought a pair of rotors and pads, the pads were wagers. This is for a 2003 Honda civic. I "believe" that these are the right pads. When I went to put the outward facing pad on it slid in there ...
1
vote
1answer
1k views

Is it safe to Drive an hour or more on the highway after a brake pad change?

So I recently replaced the brakes pads on my Vehicle. After I did the change I drove it around my Neighborhood for a short time. I got back to my garage and the Rotors were super hot. Which I have ...
1
vote
1answer
52 views

How can I check if the new brake pad will fit my caliper before buying?

I am trying to get a set of EBC redstuff brake pads for my 2019 mazda 3 hatch. How can I tell if it would be compatible? And would I need new "sport" oriented rotors with those cooling vents to go ...
1
vote
2answers
112 views

I got new tires installed and now the left rear brake is stuck

2008 Honda CRV. Like I stated, I got new tires recently. I was trying to save a couple bucks, and went with a body shop that had a tire balancing machine. I think they messed up, because ever since I'...
1
vote
0answers
11 views

Brake Pads on a Jeep Patriot

I have recently changed the brake pads on my Jeep Patriot. It seems to me that the pads just "sit" inside the caliper as opposed to actually being attached (in some shape, way, or form) to something. ...
1
vote
2answers
154 views

What breakpad height for 256mm disc

I am going to replace the front break discs and brake pads of my opel vectra b 1997 1.6 16V sedan . The discs are ZIMMERMANN 430.1461.20 256mm. But I cant decide between ate brake pads 13.0460-7052.2 ...
1
vote
2answers
504 views

My brake pads on one wheel only last a month or 2 each time I change them?

I have a 2007 Pontiac G6, 4 cylinder. About a 4 months ago in January I almost got hit by a Dodge Durango that ran a light and almost crushed me literally headed straight for the driver door. So i ...
0
votes
3answers
131 views

Brake pad wears faster than other three

I've changed all my calipers, all my rotors, and all my pads in an attempt to fix this problem, but it has not gone away. My rear passenger brake pad wears fast, to the point where it begins to grind,...
0
votes
1answer
30 views

Mixing brake pad materials, front and rear

I have a 2004 Subaru Outback, disc brakes front and rear. Some time ago, I bought some ceramic brake pads (Duralast Max) for the front, and didn't realize I forgot to buy the same for the rear. ...
0
votes
1answer
56 views

Performance brake pads for regular driving [closed]

For an average vehicle such as a 2002 Honda Accord that is used for regular driving around town, to and from work, etc. and absolutely not use for performance activities such as racing, and also no ...
0
votes
1answer
17 views

How to diagnose single sided brake locking?

Car: Mazda MX-5 MK1 1.6 with 1.8 brake kit, no ABS So, I had a front passenger side sticking caliper, which I replaced. I kept the brake pads as they had only a few millimetres of difference on the ...
0
votes
1answer
45 views

Clio 2 1.2 1998 strange sound from brakes

When I'm applying a brake there is coming strange sound from left front wheel. My guess was that it's coming from brakes, so I disassemble the wheel. Below is a picture of breaking pads and rotor from ...
0
votes
1answer
71 views

What type are 2016 Subaru Forester OEM brake pads?

Facing replacement of rotors and pads in my 2016 Forester, I consider non-OEM parts. Thus, I was trying to figure out what type are the OEM pads (i.e., semi-metallic, ceramic). I could not find this ...
0
votes
0answers
21 views

Brake pad change - passat 2011

Implausible signal Brakes fail Very dissapointed
0
votes
1answer
112 views

What is a usual value for the dimensional tolerance of brake pads?

Is there a specific regulation for the maximum tolerance allowed while manufacturing brake pads? If not, what is a usual value set by manufacturers? I would really appreciate references. Thanks a ...