Questions tagged [bearing]

A device intended to reduce the friction between two metal components moving against each other. In particular, rotating components against their mounting.

Filter by
Sorted by
Tagged with
1
vote
0answers
50 views

Replacing Nissan Qashqai 2L (2008) Bearing Kit - RE0F10A

I'm working on repairing the automatic transmission in a Nissan Qashqai 2008 (2L engine). Specifically, trying to replace the transmission bearing (RE0F10A) using this kit: https://www.ebay.com/itm/...
1
vote
1answer
1k views

Bearing features (2RS versus 2RSH)

I have done sufficient googling to discover that a -2RS bearing is one with two rubber seals. I haven't ascertained much beyond that. For an application currently using a 2RSH bearing, can I replace ...
0
votes
1answer
58 views

What effect would a hole out of the bore at the bottom be?

My end cap bolt dislodged from the piston and ended up in the sump, it broke right through the bore at the bottom making a small hole about 0.5cm^2. I was intent on replacing the piston and bearing ...
0
votes
1answer
6 views

Choosing replacement seals for trailer hubs?

How do you know what seal to use as a replacement for a trailer hub? When you replace the bearing it seems straightforward - the numbers on the existing bearing can be used to pick a new one. But ...
0
votes
1answer
5k views

Whirring/slight grinding noise on acceleration at high speed

Car is a Mk1 Golf with manual 5 speed and 1.8lt engine. When travelling at above 60kph and accelerating or cruising I've noticed a slight whirring, or grinding noise. It almost sounds like a tyre is ...
0
votes
2answers
170 views

2001 f150 excessive spindle, bearing(inner and outer) and rotor wear

Since Jan 2017 I have paid the repair bills for replacement spindles, rotor's and bearing twice on each side. And the parts are not cheap. Is there something I'm doing wrong when replacing these parts....
0
votes
4answers
586 views

Do you have to machine the crankshaft after a spun main bearing?

I had a spun main bearing due to low oil, the crankshaft journal is pretty scratched, no dents just looks spun on the surface. To the inexperienced diyer it's hard to imagine this would be a huge ...
0
votes
0answers
40 views

Is clutch bearing wear still an issue with modern manual cars?

Decades ago I was told repeatedly to press the clutch pedal in manual cars for as short a moment as reasonable, since prolonged clutch disengagement leads to excessive wear of the clutch bearing, ...
0
votes
0answers
22 views

SRS light on and possible bad rear bearing Chevy Aveo

A couple of months ago the airbag light went on for no apparent reason. When I turn the ignition on, it goes off, and turns on again, without blinking, and with no errors (read with a cheap scanner). ...
0
votes
0answers
50 views

What is the biggest bearing that I can find in car?

I want to buy inner bearing puller set for car maintenance( sedan, off-road, SUV). Which set diameter should be sufficient? 12 - 46 mm 12 - 70 mm 12 - 110 mm I don't wont to buy too small of a ...
0
votes
1answer
1k views

Bottom End Knock

I'm looking to purchase an engine with a bottom end knock, with the assumption that I will be able to rebuild it with no previous experience, fitting aftermarket forged parts. These are my ...

1
2