Questions tagged [bearing]

A device intended to reduce the friction between two metal components moving against each other. In particular, rotating components against their mounting.

9 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
36 views

Are a bearing and C-clip all you need to replace a from wheel bearing?

I need to double check this. My front wheel bearing is busted(by someone eles analysis) on a citroen picasso 2006. I have bought a bearing kit consisting of the bearing, a c clip and a nut. I will ...
2
votes
0answers
36 views

Help to modify RWD trans-axle bearing design

My project car is RWD with trans-axles running inside independent housing sleeves, as in the diagram below. The problem I have is that each axle use only one weird, fat, double track, axial bearing :) ...
1
vote
0answers
40 views

Rattling noise when accelerating in roundabouts

I have a 2007 Jaguar S-Type 2.7D version with the following problem: When I'm inside a roundabout (with the wheels steered to the left direction) and I'm accelerating (moderate to high) I hear a ...
1
vote
1answer
185 views

How to adjust differential's carrier bearings without any special tool

This differential unit comes with threaded adjusters for both carrier bearing. The car manual talks about using dial and torque gauges to adjust the bearings preload, but I don't have any of those ...
1
vote
0answers
48 views

Replacing Nissan Qashqai 2L (2008) Bearing Kit - RE0F10A

I'm working on repairing the automatic transmission in a Nissan Qashqai 2008 (2L engine). Specifically, trying to replace the transmission bearing (RE0F10A) using this kit: https://www.ebay.com/itm/...
0
votes
4answers
329 views

Do you have to machine the crankshaft after a spun main bearing?

I had a spun main bearing due to low oil, the crankshaft journal is pretty scratched, no dents just looks spun on the surface. To the inexperienced diyer it's hard to imagine this would be a huge ...
0
votes
0answers
40 views

Is clutch bearing wear still an issue with modern manual cars?

Decades ago I was told repeatedly to press the clutch pedal in manual cars for as short a moment as reasonable, since prolonged clutch disengagement leads to excessive wear of the clutch bearing, ...
0
votes
0answers
22 views

SRS light on and possible bad rear bearing Chevy Aveo

A couple of months ago the airbag light went on for no apparent reason. When I turn the ignition on, it goes off, and turns on again, without blinking, and with no errors (read with a cheap scanner). ...
0
votes
0answers
50 views

What is the biggest bearing that I can find in car?

I want to buy inner bearing puller set for car maintenance( sedan, off-road, SUV). Which set diameter should be sufficient? 12 - 46 mm 12 - 70 mm 12 - 110 mm I don't wont to buy too small of a ...