We’re rewarding the question askers & reputations are being recalculated! Read more.

Questions tagged [axle]

A shaft that intercepts the center of a wheel or gear, usually referring a shaft attached to the wheels on the bottom of a car, truck, or other vehicle.

Filter by
Sorted by
Tagged with
7
votes
4answers
6k views

Alignment is out of spec a tad - should I worry?

So I bought new tires recently for my 2002 Nissan Sentra and wanted to make sure that my alignment would not eat them up. Even though effectively my entire suspension/axle system was overhauled ...
2
votes
2answers
425 views

Tire Vibration from right rear tire at high speeds

The tire appeared to have a slow leak as I kept having to add air to it. So, I used Fix a Flat and now I have vibration at high speeds from that tire. What do you think might be the problem. I have ...
2
votes
1answer
1k views

Axle nut sizes on a 2001 Honda Shadow

It seems that the axle nut on a 2001 Honda Shadow are different sizes on either side of the bike. What size are these so I may get the correct wrench to work with them. I have tried other sources ...
3
votes
2answers
2k views

How do I replace front CV axles for a 2004 Subaru Impreza Outback Sport?

A mechanic has found that I have two split CV joint boots on my 2004 Subaru Impreza Outback Sport, and I want to try and replace the axles myself. However, the shop manual for the drivetrain is very ...
1
vote
3answers
1k views

Rhythmic sound coming from rear end

There's a rhythmic sound emanating from my rear end, and I'm not sure what exactly it is. It varies with speed and is consistently present, regardless of clutch in/out, acceleration/deceleration, etc....
5
votes
2answers
8k views

How do I remove the front axle of a 93 Honda FourTrax 300?

I'm working to rejuvenate a 93 Honda FourTrax 300 4x4, that's been stored in a garage under piles of junk for the past 15 years. I've got it running, and have turned my attention to the torn left ...
2
votes
2answers
43 views

What is a re-manufactured CV axle?

Today I replaced the passenger side CV axle of my 1994 Camry LE 4 Cyl. The package of the CV axle was saying 'remanufactured'. Should I assume that it was not new?
4
votes
1answer
3k views

Can't remove stuck rear dirt bike axle

I'm trying to remove the rear wheel on my 2007 Suzuki RMZ450. I've removed the axle bolt and tried banging the axle with a rubber mallet for about two weeks now. IT WON'T BUDGE. Not even a little bit. ...
3
votes
2answers
23k views

Should I grease an axle when I replace it on my motorcycle

I have a taken the front wheel out of my motorcycle to replace the tyre. When I put the axle back in is it a good idea to grease it? If so what type of grease should I use?
0
votes
1answer
257 views

Toyota 4-runner front axle

I recently ran into a big problem with my driver side front axle on my 1995 toyota 4-runner. for some reason its not wanting to act right. I replaced the axle, bearings, rotor, sway bar, bushings and ...
2
votes
2answers
110 views

Installing ubolts - How to push the slip joint forward

I'm in the process of removing the lift blocks from my 2000 silverado z71. Now that I'm ready to install new ubolts I've realized that the driveshaft and axle have slipped backwards away from the ...
4
votes
2answers
653 views

What is the best way to clean axle components?

I'm currently servicing (changing seals/gaskets, some cleaning and repainting some parts) my front axle on a Toyota Land Cruiser 87. I'm also putting new brake rotors/calipers/pads. What is the best ...