Stack Exchange Network

Stack Exchange network consists of 175 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

Questions tagged [axle]

A shaft that intercepts the center of a wheel or gear, usually referring a shaft attached to the wheels on the bottom of a car, truck, or other vehicle.

5
votes
2answers
8k views

How do I remove the front axle of a 93 Honda FourTrax 300?

I'm working to rejuvenate a 93 Honda FourTrax 300 4x4, that's been stored in a garage under piles of junk for the past 15 years. I've got it running, and have turned my attention to the torn left ...
3
votes
2answers
21k views

Should I grease an axle when I replace it on my motorcycle

I have a taken the front wheel out of my motorcycle to replace the tyre. When I put the axle back in is it a good idea to grease it? If so what type of grease should I use?
9
votes
5answers
18k views

Why don't FWD cars have rear differentials?

This confuses me. The point of a differential is to make it so the wheels don't slip when one needs to be turning faster than the other, such as during turns. So if the rear wheels are directly ...
7
votes
4answers
6k views

Alignment is out of spec a tad - should I worry?

So I bought new tires recently for my 2002 Nissan Sentra and wanted to make sure that my alignment would not eat them up. Even though effectively my entire suspension/axle system was overhauled ...
0
votes
1answer
257 views

Toyota 4-runner front axle

I recently ran into a big problem with my driver side front axle on my 1995 toyota 4-runner. for some reason its not wanting to act right. I replaced the axle, bearings, rotor, sway bar, bushings and ...
4
votes
1answer
117 views

Leaking axle bearings

In my Bronco, the 9" rear axle has the tapered roller bearings and has started leaking. With these bearings (Timken Set 20) is there supposed to be an inner axle seal? I have just been using the ones ...
7
votes
4answers
22k views

Bad CV joint, but which side?

Honda Accord EX 1990, just bought. When I make a tight turn, I sometimes hear a rhythmic clunking sound. This is supposed to be a tell-tale sign of a worn CV joint. But how do I know which side it's ...
2
votes
2answers
107 views

Installing ubolts - How to push the slip joint forward

I'm in the process of removing the lift blocks from my 2000 silverado z71. Now that I'm ready to install new ubolts I've realized that the driveshaft and axle have slipped backwards away from the ...
4
votes
2answers
629 views

What is the best way to clean axle components?

I'm currently servicing (changing seals/gaskets, some cleaning and repainting some parts) my front axle on a Toyota Land Cruiser 87. I'm also putting new brake rotors/calipers/pads. What is the best ...