Podcast #128: We chat with Kent C Dodds about why he loves React and discuss what life was like in the dark days before Git. Listen now.

Questions tagged [air-intake]

The point at which air enters the intake tract of a motor vehicle or stationary engine

Filter by
Sorted by
Tagged with
29
votes
7answers
17k views

When is a cold air intake system beneficial?

Cold air intake must be one of the popular mods there is, and one subject to the most controversy as well. Manufacturers of such systems advertise 5-20 HP gains, yet there are claims that this mod ...
10
votes
2answers
728 views

Why Have More Than One IAC Type Device On an Engine?

I've had two Mazda's, a 97 323 and 98 626. On both these car's engines there was only a single IAC mounted on top of the throttle body, and no other device for adding air flow on the intake side. ...
6
votes
2answers
69k views

Effects of driving through deep water WITHOUT hydrolocking (car still bogged down and died)

So, yesterday we had very heavy rains, and unfortunately I was driving in an unfamiliar area of town. I drove through high water, which caused my car to sputter and so I turned around. The car behaved ...
6
votes
1answer
4k views

Oily Sludge in the Intake Manifold

When taking off the throttle body to clean my IAC, I noticed that there was a thick layer of oily sludge coating pretty much everything inside the intake manifold: I have two queastions: How did ...
18
votes
7answers
10k views

Why or why not increase engine efficiency by running the car “fuel-lean” (using a turbo or supercharger)?

Everyone wants their cars to use less fuel, right? I read the following passage about running the car fuel lean from this website: Run the engine fuel-lean, that is, use excess air. It is well ...
12
votes
2answers
9k views

How do variable-length intake manifolds work?

I have heard many vehicle manufacturers have been using this to improve power and torque figures. They do this by altering the length of the manifold, I am hoping for better diagrammatic explanation.
3
votes
1answer
596 views

Why is this hollow plastic piece attached to the Karizma's air intake?

I was helping my cousin with a motorcycle teardown a while back (planning for a café racer build) and was puzzled by something on his '07 Karizma. The red arrow in the picture above points to a ...
1
vote
2answers
777 views

Calculating fuel flow rate through obd || sensor not supporting 015E and 0110 commands

I have been working on a project where i want to calulate fuel flow rate using data from the obd2 sensor. The car on which i was testing didn't support the pid 015E which is for fuel flow rate. Then i ...
15
votes
2answers
2k views

Yamaha R1 intake tract configuration

Interesting Configuration The Yamaha R1 has a very strange intake design. Notice the intake horns in the image below. They sit above the throttle bodies and are not attached directly to them ...
9
votes
3answers
30k views

What are the pros and cons of installing a high-performance air filter on a bike?

What are the advantages and disadvantages of installing high performance air filters (K&N,Green cotton,etc.) over original filter? What are the changes/working occur internally?
6
votes
1answer
747 views

Help me diagnose the cause of this intake valve burn

I would like some help diagnosing the probably cause of this intake valve burn as seen in the picture. 167fmm engine. 229cc OHV push rod type. Now here is the rub. this is engine originally 9:1 CR, ...
3
votes
1answer
34 views

Could broken air filter seal/gasket impair intake?

I am getting a P0101: Mass or Air flow Circuit and noticed that my air filter gasket is getting dangly in places, which might be causing it not to seal well. Could that be causing impaired air intake, ...
3
votes
3answers
1k views

Could taking coolant through the intake filter realistically cause permanent inability to start?

Diagnosing failure to start on a 2001 Honda Prelude SH, still in brainstorming phase. Leaving out list of other thoughts because this question is specifically about this possibility, rather than ...