0

So the car will run and drive(mostly) but has codes flashing saying the "crankshaft sensor" is unlearned and keeps going into limp home mode. Does it need to be programmed again? It was programmed prior to shipping and i installed it and everything was done right i dont understand what else needs to be done

Improve this question
2
  • 1
    Welcome to Motor Vehicle Maintenance & Repair! If you have checked the codes, are you getting a P1336? There are procedures for doing a crankshaft sensor variation relearn.
    – Pᴀᴜʟsᴛᴇʀ2 ♦
    Jun 29 at 16:43
  • I believe so, yes!
    – Kacey Buckley
    Jun 29 at 20:10

0

Reset to default

You must log in to answer this question.

Browse other questions tagged .