I've been trying to get a
Poulan Pro leaf blower engine to run. I had noticed that the seal for the engine isn't tight and I saw that the threads were stripped. I know compression is needed for combustion.
I tried using a simple thread restorer kit but it didn't hold. I tried a bigger thread creator, and now the original bolt is too small. (I was probably being an idiot and wasn't paying attention.) Does anyone know a way I can hopefully restore the seal and threads?
The model information on the cover is:
25cc Gas Blower 200mph Bvm200FE Poulan Pro
here is where the seal I'm referring to is: