1

I'm attempting to change a CV boot on my 1988 Accord. To do this I must remove the axle.

I've remove the wheel, hub and suspension and so have the outer-side of the axle exposed.

But how do I remove the inner side of the axle (the part that connects to the transmission)? I can't find any info on this. Can I just pull it out?

  • Just a note, but if you're removing the axle to change the boot, it's often a lot easier (and not much more expensive) to just replace the axle. – PeteCon Oct 28 '19 at 14:08
  • @PeteCon yeah I've heard that. Unfortunately, these were not a too common car here in Australia so I can't find any that aren't over $100 in shipping alone. Luckily they still stock the boots here. – MeltingDog Oct 28 '19 at 22:21
4

If you look to the very right in this image:

From Rockauto.com

You'll see a snap ring. This holds the end of the axle in the transmission. To get it out, you need to wedge something like a long flat tip screwdriver or pry bar in between the transmission case and axle, and pop it free. It will take a little bit of finagling, but it will pop out. Don't pull on the axle shaft itself, as you risk pulling the CV joint apart.

  • Awesome, thanks @Paulster2. I imagine to reinstall you'd just push it back in until it clicks? – MeltingDog Oct 27 '19 at 22:59
  • @MeltingDog - Yes. It can be a little tricky sometimes. Don't be afraid to use a little force (ie: pressure ... don't hammer on it with anything ... wouldn't be good). – Pᴀᴜʟsᴛᴇʀ2 Oct 27 '19 at 23:04

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.