2

After a severe pothole, I bent very slightly my front right rim right before a road trip. As the effect wasn't noticeable, I went on my road trip.

I noticed the clamp on my CV boot had gone loose on the side which points the wheels itself.

I am just wondering is it, in theory, possible that the bent rim is causing too much vibration and therefore loosening the clamp or was that just a result of a bad repair job (a couple of weeks ago I had the boot replaced after I ran over a shoe which tore it open)?

P.S. I'll fix the bent rim this week most likely.

  • The bent rim was not likely to be the cause of the cv clamp being loose. But you need to get this sorted properly. – Solar Mike Sep 30 '18 at 19:28
  • 1
    Thanks for the reply! The shop took responsibility and fixed it for me at no cost on the same day I reported it. They're my go-to guys and I accept a mistake sometimes happen and they dealt with it properly. It has been fixed for around a week with no issues but I had been second doubting the bent rim as a possible cause. – Tisho Sep 30 '18 at 19:33
  • Welcome to Motor Vehicle Maintenance & Repair! – Pᴀᴜʟsᴛᴇʀ2 Sep 30 '18 at 20:18
1

A bent rim, even one severe enough to cause vibration, will not loosen a CV clamp that is already subject to constant vibration.

| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.