0

Bought a new upper o2 sensor but the clip on wiring harness is melted so I want to straightwire them to o2 sensor.

  • Harness wires... black, tan, gray, green with orange stripe
  • Oxygen sensor... black, gray, white, white
  • Can you identify the original position in the melted clip - that will tell you which wire goes with which... – Solar Mike Jun 20 '18 at 5:18
  • Sorry.. no. O2 sensor went out so I changed it. And then... – Erica Hiatt Jun 20 '18 at 5:38
  • No melted to bad. Cut both ends around melted clips but can't color coordinate them together – Erica Hiatt Jun 20 '18 at 5:44
2

Here are the pinouts for the truck harness side of the O2 sensors, upstream and downstream. This should give you a sense of wire color and clock location in the plug.

You may need to go to the parts store and take a picture of an undamaged O2 sensor to get things connected properly.

enter image description here

enter image description here

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.