Rode it today ran fine. Come back home and I stalled it. 20 minutes later I turn the key to ride it again and nothing. I have no lights of any sort.

I did check the fuses and they seem ok. What else should I try?

  • 5
    This seems to be your first posting here. Welcome. I will say generally folks leave a bit more detail on what they've tried. Have you reviewed the electrical schematic for your bike? Do you have access to a multimeter? Check that same site to get the complete service manual for your bike. I'm guessing there is a guide in there that tells you what component is what on that diagram.
    – zipzit
    Commented Jun 1, 2016 at 6:25
  • 1
    Do you know where are all the fuses are? Did you test your battery? Commented Jun 1, 2016 at 21:35

1 Answer 1


Make sure to check all of the safety features that were included on the bike. Kickstand up, in neutral, clutch in, kill switch set to run, and key on.

  • Charged the battery over the night and now the lights turn on and starts. Thanks pointing me in the right direction though Commented Jun 1, 2016 at 22:50

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .