0

This question already has an answer here:

Bought 02 upstream air fuel for 04 Honda Civic it came with a male connector while the old has a female connector the connector on the car is male so I cut the connector off the new sensor how do I join the wires?

New 02 colors: black, black, blue, white

Old 02 colors: black, black, green, white

|improve this question

marked as duplicate by Moab, MooseLucifer, Pᴀᴜʟsᴛᴇʀ2♦, DucatiKiller, kmarsh May 26 '16 at 2:19

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

  • blue = green, its the only one that does not match. – Moab May 25 '16 at 23:16
  • 1
    This question is not a duplicate of the O2 sensor wire question because it is an AFR sensor and therefore cannot be substituted and rewired. – Fred Wilson May 26 '16 at 4:12
  • Welcome to the site Oral. Using all caps is bad practice for the internet in general, so I edited the question to have normal capitalization. – JPhi1618 May 26 '16 at 12:10
2

This will not likely work. If the sensor is not the correct part number for the specific vehicle it is unlikely that it will match the exacting electrical specifications needed for the PCM to control and read the sensor. AFR sensors are matched to the PCM. Unlike so called "oxygen sensor" which can more often be interchanged across different engines and control systems.

|improve this answer
1

I agree with @fredwilson on this one you probably just screwed your self by cutting the connector off. You should of taken the sensor back and gotten the one appropriate for your car.

In any case your going to have to cut the connector off the old sensor as well. Keep track of where the wires go into the connector and solder or crimp the connections.

|improve this answer

Not the answer you're looking for? Browse other questions tagged or ask your own question.