4

When doing things like setting TDC or just random testing (of the timing chain/belt, for example), does it matter whether the crankshaft is rotated clockwise or counterclockwise?

3 Answers 3

3

Hardly ever. Most turning should be done clockwise. If you need to rotate it back a few degrees to get it to the specific TDC point, it's not an issue. This will not cause any damage to your engine. If using the main bolt in the end of the crankshaft, you do run the risk of it loosening when turning it CCW ... but that isn't a big deal either. Just tighten it back up by cranking it back over CW, then get the crank back to where you want it to be. Usually if done easily (no sudden jerks), the bolt in the crankshaft will not loosen and is a good place to rotate the engine from.

3

Not at all, in fact in some engine manuals, ignition section, they instruct to move clockwise up to TDC then counterclockwise before 10 degree mark, then again clockwise until that mark in order to effectively find where the spark should jump. The manual states that's needed in order to exclude any back play in the distributor's coupling gears to camshaft. The only thing to considerate is to be sure, if you are rotating by damper, or its bolt/nut to crankshaft, it is well secured because otherwise you would loosen these.

0

Even if your cams are gear driven it should be in the same direction as normal operation, but chains especially have a "slack side", and under load it is slacker than you think. When refitting timing belts and lining up the scribe marks you should be torquing the crankshaft in the normal direction of rotation. You don't want to be out by one tooth.

Be careful never to rotate the crankshaft out of the "safe zone" if the camshaft is decoupled.

For timing, and if the chain is suspect, better to test with a light while it is running (as it may be jumping around in this case) a road test may be the best method of tweaking.

1
  • Just to clsrify, some engines can run in both directions by design (2 stroke, steam).
    – mckenzm
    Mar 2, 2018 at 0:40

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .