Hot answers tagged

3

The parking lamp/headlight switch applies power or ground so the circuit would be open if you were testing with the switch off. Same with the turn signals. The tail lights are on separate circuits. They don't share a ground. Does the car have an aftermarket trailer harness? If not your going to have to remove panels and visually inspect the harness for ...


1

Blue Green is the indicator wire for the left rear, blue brown for the right rear. Assuming USDM.


1

If you are looking to figure out which wire goes to which, an easy way to figure this out is to have a source which produces 12vdc and has the two leads for (+) and (-) with probes attached, plus a pad and pencil to mark down what is what. After you have your 12v source and other supplies to get started, take the bulb section out of the housing so it looks ...


1

I'm going to answer this in a general way because for someone to tell you what the wires mean, they would need to follow this procedure, or have access to detailed wiring diagrams for your car. You'll need a multimeter for this, and you'll have to take apart the brake light as if you were changing the bulbs so you have access to the bulb sockets. I'm ...


1

Left brake light was not working. The brake light would come on when turning on headlights so I knew the bulb was good. Bam! Contact with the housing was the problem. Manually pulled the small contact tabs out to make better connection. Also swapped the right light for the left and they both worked.



Only top voted, non community-wiki answers of a minimum length are eligible