Tag Info

New answers tagged


Sounds like the wire is mounted incorrectly at the points. There is an insulator where the wire in connected. Make sure the wire is connected to the points spring arm, and not to the base or mounting hole. If it is connected there it will be grounded all the time and will never produce spark at the coil. To check this, disconnect the wire and turn on the ...


I am assuming you removed the original condenser if it didn't have a uniset in it when you changed them. That being said, it sounds like the points are either not fully seated or adjusted way off. Loosen the screws and try pushing down while trying to slide the point set. There is a hole that the point pivot must fit into or it will not seat properly ...

Top 50 recent answers are included