Hot answers tagged

2

Basically, you want a device to activate when the 'system' is 'armed' and the door is opened. The easiest way to do this would be to tap into one of the outputs of an existing system, or install an aftermarket alarm system. If you want a completely different system, you will need door pin sensors to determine when the door has opened. You MIGHT be able to ...


2

I believe the best place to make this change would be at the fuse box using a separate fuse. You will need a wiring diagram for your vehicle to identify the wires going from the fuse box exclusively to the bulbs. "I need to supply to each light individually - or just one and the current will spread to the rest?" Each bulb needs to receive current from its ...


1

If your car has a vibration sensor, you can typically set the sensitivity. You can test this by bumping into your car or trying to rock it a bit.


1

recently... i have done this before. What i'm doing is... i connect directly to left/right respectively. one wire connect to left signal and another one to to right signal. For simple car, i think should be no problem. My car so far so good.



Only top voted, non community-wiki answers of a minimum length are eligible