0
votes
2answers
605 views

Torque and engine power [duplicate]

What is the relation between Torque and engine power? Just wanted to know how power is distributed to wheels in a car.
2
votes
1answer
388 views

Squeal (vacuum leak?) and high idle after rebuilding carbs on '82 Yamaha XJ 750 Maxim

I've got an '82 Yamaha XJ 750 Maxim. I rebuilt the carburetors this weekend, and after putting it back together, it seems like it's got a vacuum leak. There's a loud squeal every time a cylinder ...
0
votes
2answers
332 views

Why doesn't the engine coolant dry up while the engine is running?

Why can't coolant dry inside the engine during engine operation?
3
votes
2answers
44k views

What is the purpose of a drive-shaft?

what is a drive-shaft and why we need it in a car? I do get the point of having crankshaft (using Wikipedia) but still confuse with drive-shaft
-4
votes
1answer
236 views

Why need to change gear in car? [closed]

Could someone let me know why it is necessary to change from gear to gear ?What is the scientific foundation? I heard " The higher your speed the higher your gear, the lower your speed the lower your ...
0
votes
2answers
2k views

Adjust sector shaft on newly installed steering gear box?

I replaced the steering gear box on my 2004 E250 with a remanufactured one. I'm still getting play in the steering wheel, about an inch as measured by the circumference of the wheel. I took a look ...
2
votes
5answers
2k views

Yamaha XJ750 not starting

I would like to thank all in advance for any advice I recieve. I own an 82 Yamaha 750 maxim, I have got single air breathers, for my 4 carbs and I removed the carbs to clean out and install air ...
3
votes
1answer
213 views

What is the bank sensor attached to on a Honda CBR1000RR 2012?

I am repairing a bike which had its front totally taken out. The instruments panel and headlights are gone. One of the first things I'd like to do is install a new bank sensor. I purchased the bank ...
2
votes
2answers
1k views

Is it possible to install power door lock on KIA Forte LX?

My 2010 KIA Forte LX has no power lock from stock, but it has wires in doors. Is it possible to put lock actuator from EX model? Or in any other DIY way? I've checked a lot of forums, but there is no ...
4
votes
1answer
88 views

Why wasn't my engine getting fuel?

This is a 1975 Ford F-350. It has been sitting idle for 6 months, and is rarely used. Normally, when I try to start it after sitting for a long time, it takes a bit of cranking before it starts. I ...
4
votes
2answers
535 views

Noisy blower fan in 92 Civic

The blower fan in my Civic is really loud on the high setting; from inside the vehicle, it's much louder than the engine and even louder than wind/road noise at highway speed. Reaching up under the ...
2
votes
1answer
936 views

Ford Fiesta - the colour of the water in the water container

I own a hatchback ford fiesta. I took my car out for a drive today for 10 minutes and when I came back, I opened the hood and checked that the water in the water container was quite hot (not ...
2
votes
1answer
287 views

Remove stuck steering gearbox mounting bolt?

I'm removing the steering gearbox from my 2004 E-250. I'm trying to remove the gearbox from the frame, but one of the three bolts that mount it to the frame is stuck. I've managed to get the bolt ...
2
votes
1answer
80 views

1999 Ford Interceptor 4.6 L not starting

After replacing the intake the car will not start. The lights on the dash come on, the fuel pump pumps, the fuel rail has been bled. And yet when I turn the key, no click just some relay clicks after ...
1
vote
1answer
473 views

2008 Chevrolet Impala. Clicking noise behind the glove box - I believe it has something to do with a diverter valve in heating and cooling system?

There is a clicking noise behind the glove box. I believe there should be a sensor or something to stop the motor for the divertor valve. It trys to keep shifting the valve and it clicks when it ...
2
votes
1answer
615 views

Evap code continues to warn after replacing the gas cap

Replacing the gas cap as suggested here worked for about a week. But now the check engine light (evap code) continues to re-appear. This is about the third time in three months the check engine light ...
5
votes
2answers
2k views

Replacing the head gasket in a 1993 Mercedes 300ce

Is replacing the head gasket in a 1993 Mercedes 300ce, an expensive repair? I've been told it is better to just replace the engine all together. Is it a tough job for a backyard mechanic or a diy ...
2
votes
1answer
409 views

Whistling noise from 4runner when idling, gassing

Our 2000 4runner just started making a noise a few days ago. It’s not very noticeable unless you roll down the window. It is high pitched, and when it happens it’s intermittent, never a longer tone ...
3
votes
2answers
507 views

Intermittent no crank issues

My girlfriend has 2003 VW Beetle (2.0L, 5-speed manual). Sometimes, when you turn the key to crank over the car it tries to turn over but then hits a wall. No clicking happens at all. It starts to ...
4
votes
1answer
118 views

Where on the Jeep Wrangler TJ can I tap into the oil line?

I would like to install a By-Pass filter on my Jeep TJ (2004). Where can I put the other end of the tube going into the filter? I have included a diagram illustrating what I am looking for (where ...
5
votes
3answers
12k views

Cigarette lighter fuse repeatedly blows

I have a 2000 Toyota Corolla. Recently, the fuse for the cigarette lighter blew when I put in a car charger. The fuse powers the cigarette lighter as well as the radio and I think the backlighting on ...
1
vote
2answers
183 views

Can I mix synthetic and mineral oils?

I cannot find out for sure if the oil that I'm using is synthetic or mineral. I have suspicions that it is mineral based on unreliable web sites, but the recommended oil for my car (Renault Megane MK1 ...
1
vote
1answer
557 views

2002 Chevy Malibu spark plugs

Three of the spark plugs in my 2002 Chevy Malibu are easy to reach and change, which I did successfully. The other three spark plugs are difficult to reach, difficult to see, and are in a position ...
4
votes
1answer
106 views

Broken spark plug

How do I remove a spark plug broken off in the engine block of a 2002 Malibu? I successfully removed and changed three spark plugs in my 2002 Chevy Malibu. The fourth one broke off.
2
votes
3answers
608 views

VW Jetta II - engine misfires when climbing a hill

This is a VW Jetta made in 1984 with 1.6L petrol engine (code "EZ"). It starts OK (though if it has been a wile since last start, it takes some cranking to start the engine), but when climbing a hill, ...
6
votes
3answers
5k views

Chronic ignition problems with 1996 Suburban, replacing distributor cap makes it go away

I'm trying to diagnose an ongoing ignition problem with a 1996 Chevy Suburban. Sometimes it won't start, and the previous owner said this happens regularly, and every time the problem occurred, ...
0
votes
2answers
8k views

My 2003 Grand Am won’t start

I have a 2003 Pontiac Grand Am that would not start. All the lights, power windows, radio etc. work, but when you turn the key it is silent. It won’t even jump start. I had also put in a new solenoid, ...
4
votes
4answers
2k views

High Beam Indicator Problem

I have a situation where I'm doing wiring for the dashboard of a vehicle. For whatever reason, the turn signal/headlight switch on this vehicle outputs a 6 volt signal on the high beam wire when the ...
4
votes
1answer
128 views

Carbon Fouled Plugs '74 TX500

I'm somewhat new to wrenching my bikes and I'm loving it! :D I have a 74 Yamaha TX 500 that keeps carbon fouling her plugs :(. I've put on slightly hotter plugs (D7EA from D8EA), narrowed the jets ...
8
votes
2answers
718 views

What could be a likely cause of unusual “torque steer” after repairs?

I have a 2012 Dodge Avenger SXT. Recently, I had a collision with an inanimate object which damaged my front-right tire and rim and also caused some very minor body & paint damage. Immediately ...
5
votes
2answers
623 views

Does the a gasoline or diesel engine supply fuel at high speeds when not pressing the pedal and more

Let say I directly connect a small engine to my bicycle, and that I'm superman who can overcome any force. Then I start cycling (using my legs...) - the engine starts to rotate, even though I haven't ...
6
votes
2answers
949 views

What's the proper method of replacing the crank shaft oil seal of a Honda Rebel?

I've been searching for a guide, but haven't found anything the deals with the oil seals specifically. My '09 Honda Rebel is leaking oil into the flywheel cover, and I suspect the flywheel and crank ...
2
votes
1answer
324 views

Could you provide an outline of switching the side of the rear fog light?

I am obliged to have my rear fog light on the left side, but it is on the right. I've never fiddled around with my Fiat Punto '94, but I'd like to make the switch myself, if you don't advise against ...
2
votes
2answers
115 views

What is a fair price for caliper repair?

Dealership tells me I need a rear wheel caliper repair. Estimated cost of $500. Is this reasonable? I have Toyota Highlander 2003 model.
3
votes
2answers
100 views

Will low gauge wire to a fuse be a bottleneck?

I am running 4awg wire to my car's 400watt amplifier. The wire is running about 10 feet from the circuit breaker that it is connected to. The circuit breaker (as of now) is connected to the car's ...
2
votes
1answer
157 views

identify suspension leak on motorcycle

Especially after a good cleansing when there is no visual signs of a spil, I found it hard to detect problems with oil leaks/levels. Usually I can feel low levels in a rear mono suspension when ...
3
votes
3answers
2k views

Will a universal catalytic converter set off the check engine light on an Infiniti G35?

I have a 2004 Infiniti G35 and the bank 2 catalytic converter has triggered the check engine light. If I replace it with a universal Magnaflow catalytic converter (approximately $100) will the check ...
3
votes
1answer
180 views

How should I go about zeroing dial calipers?

I have a pair of very nice dial calipers that display marks every 0.001" and can be used to round to the nearest .0002" accurately. How should I go about centering these so that they are as accurate ...
5
votes
3answers
1k views

1991 Honda Accord with intermittent brake lights

I've got a 1991 Honda Accord with three brake lights, one on each side and one in the rear window. For reasons I have yet to discover, I can't get the right brake light and the window brake light to ...
0
votes
2answers
383 views

Is that easy to start a car like in the movie Parker?

In the movie Parker Jason Statham/Parker steals about 4-6 cars in the movie. Every car he steals he starts the engine by messing around with the wires under the steering wheel. Is it that easy to ...
2
votes
1answer
531 views

Motorcycle: Irregular brake bite (front single disk)

My motorcycle's front brake is giving a irregular bite. I don't know how to express it in words please check the illustration below. --------$^^^^^^^^-^-^-^-^-^^--^^^---^^^^^^----^^^| ~60Kmph ...
3
votes
2answers
878 views

Looking for Tyres for Pulsar 150 bike with 180cc engine

I have a pulsar 150 bike modified with 180cc engine. I am looking for tyres(both from and rear). The tyre should have have good cornering capability and a very good grip. Till now I have. I looked at ...
1
vote
4answers
1k views

Water pump lifetime

What is the lifetime of water pumps? I got the water pump replaced 8000 miles age (around 2 years ago) when changing the timing belt. Today I showed my car to a mechanic for a noise that is coming ...
5
votes
2answers
98 views

Paintwork damage

I want to learn how to repair paintwork damage on a car. Anyone here who can provide me with step by step instructures on how to repair the following type of damaged paintwork? The damage can be ...
3
votes
1answer
417 views

Broken part, rear wheel, Hyundai Accent 2003

I drove a long long way with my old car knowing I had to change the shock absorbers, and what needed to happen; happened. Something broke and I have now strange noise coming from one of the rear wheel ...
2
votes
1answer
1k views

How do I troubleshoot an old two-cycle engine that stalls after idling for 20 seconds?

I have a craftsman trimmer that I've not used in years. I'm using semi-old fuel mixture so I definitely know that may be contributing but I think this happened when I was using it prior to this. ...
9
votes
3answers
1k views

How to prioritize repairs?

My car needs some work, but I don't like taking out too much debt and my savings are sort of depleted for the moment, so I need to do a little at a time. How can I prioritize the work that needs to be ...
4
votes
1answer
148 views

Transmission stuck in neutral

I just recently bought a 1968 Oldsmobile 442 with a brand new transmission put in it. The guy I bought it from said there’s about 1200 miles on it but a few weeks after I bought the car I got in it to ...
0
votes
4answers
156 views

How can i sure that my purchased used car is not a stolen piece? [closed]

Please suggest me that how can i check before purchase that the used car is a stolen piece or need some repair in engine or other parts?
2
votes
1answer
149 views

What is an effective way to clean up gasoline spill?

My gas tank started leaking and left a rather large area covered in gasoline. What is the best way to remove the gasoline from the ground? This is pavement. I covered the stain in kitty litter and ...

15 30 50 per page