0
votes
1answer
51 views

Latch of cup holder in main console broken

The latch in my car console is broken. When I have checked the dealer they tell me I have to change the whole console. That costs around $300. I am looking to fix it using some glue. Has anyone tried ...
0
votes
2answers
2k views

Does a 2010 VW Jetta S (2.5 L gasoline engine) have a timing belt or chain?

The questions says it all. Does a 2010 VW Jetta S (2.5 L gasoline engine) have a timing belt or chain? Please reference where you got this information.
0
votes
2answers
17k views

my cars water overflow tank starts boiling after I drive a short distance.

My car overheated and I was only able to put tap water in the overflow I noticed once I parked my car the overflow water inside started boiling. Is that because I needed to add 50/50 coolant. Do u ...
0
votes
3answers
234 views

Losing power steering fluid 2011 Honda Accord 4cyl

Car is losing power steering fluid very slowly. Months go by before it needs to be topped of again. No apparent leak, no noise, no foam in fluid.
0
votes
1answer
897 views

What is the difference between a normal battery and a maintenance free battery in a 2 wheeler segment

What is the difference between a normal battery and maintenance free battery. Is a maintenance free battery really free of maintenance or just it requires less no of charge cycles. I currently own a ...
0
votes
2answers
148 views

What would cause a frontend to pull intermittently?

I just bought a new (to me) Sprinter van - 2006 Dodge Sprinter 2500 Van (140" wheelbase, high roof). Generally speaking, it pulls to the right, but especially when going slowly, the wheel only pulls ...
0
votes
1answer
72 views

whats with my toyota tercel after i jump started another persons vehicle

i jump started my daughters vehicle which is a 6 cyclinder with my toyota 4 cyclinder now will that affect my toyota car? . Im not sure if it was a exsisting promblem and jump starting it made it ...
0
votes
1answer
48 views

Air vent squeaks while car in on position

My kia rondo 07 if I have key in on position but not started I turn air on and it squeaks like old door hinge is that not normal or a problem
0
votes
2answers
311 views

Tail-lights not working

Why doesn't my left tail light work on my 2000 Grand caravan. I have Changed the bulb. That didn't fix the problem.
0
votes
2answers
214 views

How to repair a temperature gauge?

The temperature gauge in my 1996 Mazda 626 has been dead for as long as I have had the car (years). I never bothered to fix it because the car seemed fine. I recently had an issue where I discovered a ...
0
votes
1answer
78 views

Where and how to find compatible OBD bluetooth adapter

I need a bluetooth OBD adapter compatible with Hyundai Sonata 2002 2.0 Automatic UK. I don't know much about cars and hence ending up asking for help. I would appreciate if someone can inform me where ...
0
votes
1answer
371 views

ECT control/sensor on 2001 Chevy Monte Carlo location

Where exactly is the ECT sensor/control located on 2001 Chevy Monte Carlo?
0
votes
2answers
902 views

RPM jumps up & back down at 40mph

My question is for a 2006 Dodge Magnum, 2.7 liter engine. Just over the past month or so, I noticed when I'm cruisung, just coming from a dead stop, when I'm at 40 mph my car kinda feels like it ...
0
votes
1answer
80 views

Can I install nano fuel economizer for carb type toyota 3A engine?

Can I install nano fuel economizer for carb type toyota 3A engine? Will it help to improve fuel consumption of my car without any issue?
0
votes
2answers
270 views

In an automatic transmission, what decides to change gears? [duplicate]

So say there is an automatic transmission in a car. Is there a computer inside the transmission that decides to change gears, or is there a computer in the car that tells the transmission to change ...
0
votes
1answer
210 views

Fuel injection mechanism

It is hard to imagine injecting spray of fuels at several thousands rpm. How is it possible to pump liquid fuel at such high frequency?
0
votes
1answer
141 views

Is this kind of tire damage from a landscaping brick?

My wife and I use surplus landscaping bricks as bump-stops in our garage. They are maybe 1.5" thick and 12" wide, and are used as stop indicators at a creeping pace only. The tire is from a 2013 ...
0
votes
1answer
356 views

How much Octane Fuel does Honda CBR 250R (India Version) needs? 91 or 93?

Honda CBR250R STD 2013 Model's manual state that fuel(petrol) used should be 91 or more. Seems like they have defined the minimum threshold of RON than stating the optimum RON for the given bike. ...
0
votes
1answer
64 views

Where does the coolant go?

I filled up the coolant a few months ago and today I found the coolant level is near MIN. Is it normal that coolant "evaporates" over time? Or does it mean that it is leaking somewhere?
0
votes
1answer
224 views

polo 2012 - driver door won't unlock with key but will lock

I'm having an issue with my polo, the lock on the drivers door won't unlock but will lock once it's been unlocked via the passenger door using the same key. The key just spins infinately. It used to ...
0
votes
2answers
837 views

Add Muscles to my Tata Nano Car [closed]

Any Suggestions for Tuning my Tata Nano car into getting a muscle look and also an increase in power??.. Thanks in Advance.
0
votes
1answer
124 views

I feel my shock absorbers are no more working. Need to know if I need to replace them or are there any recommendations to ge them properly repaired?

Pulsar 150CC.. Rear shockers. Bajaj showroom Mechanic suggests to replace them but other mechanic suggests that they can be repaired. it ran around 54K. I am confused now. Please suggest.
0
votes
2answers
85 views

Which sway bars to buy?

I wish to reduce sway in my 2005 Daihatsu Copen. I have found a number of different vendors, and I have heard good things about Ultra Racing. They sell the following bars: Front Upper Strutbar ...
0
votes
1answer
2k views

humming sound from car when driving

I have a Nissan FB 15 car. Today I hear some humming sound from font wheels. I'm not sure whether it comes from the engine or wheels. It's not coming all the time. But when I increase the speed, then ...
0
votes
2answers
3k views

1997 ford f150 heater not working properly

I have a 1997 ford f150. New water pump, new thermostat 195°, heater core has been flushed out. Problem is the heat will blow warm for few mins then blow cold air for few mins. What else should we do? ...
0
votes
1answer
81 views

How can we measure the tilt of steering wheel in car without any special sensor for it?

I am searching for some possible way so that I can get the tilt or amount by which the steering wheel is rotated and without any use of special sensor for it , in Indian Cars like Swift D-Zire , Beat ...
0
votes
1answer
92 views

In the -20F temperatures last week my temperature gauge was stuck under the 1/4 mark. Heating was also affected

Now that it has warmed up, things are back to normal. Even my heat is back. I think that my thermostat was stuck, but can they get "unstuck"?
0
votes
2answers
102 views

Would it be worth it to rebuild my Detroit Locker?

I'm considering either buying a Wavetrac LSD (very expensive, so that's discouraging) or rebuilding my current Detroit Locker. The Locker seems to run fine except there's a lot of play in it. Would ...
0
votes
2answers
218 views

Radiator is getting more heated

my indica vista car engine is getting over heated. Is this because of not mixing water and usind only coolant oil, if so what should i doo now can i mix water now in that.
0
votes
1answer
40 views

Does the advantage of ballast make minimum weight rule pointless? [closed]

Rules pertaining to the minimum weight of cars in motorsport (600+ kg in F1) were introduced to prevent manufacturers from producing dangerous designs for the sake of being lightweight. However, we do ...
0
votes
2answers
383 views

Can an engine be 'too lean' at 0%/closed Throttle?

This is regarding an argument I'm looking to settle with my friend, over in particular a Triumph TT600 motorcycle. When off the throttle and above 6k RPM, the engine will 'hang' at 4.5k-5k for a few ...
0
votes
1answer
116 views

Fuel consumption: Coasting vs in gear without thrust [duplicate]

If you're driving downhill would it be more economical to put the car in neutral and coast, or leave the car in gear and let the wheels drive the engine? Please ignore any safety concerns for this ...
0
votes
3answers
1k views

Yamaha XJ750 not starting

I would like to thank all in advance for any advice I recieve. I own an 82 Yamaha 750 maxim, I have got single air breathers, for my 4 carbs and I removed the carbs to clean out and install air ...
0
votes
4answers
110 views

How can i sure that my purchased used car is not a stolen piece? [closed]

Please suggest me that how can i check before purchase that the used car is a stolen piece or need some repair in engine or other parts?
0
votes
1answer
159 views

Does a low oil level mean some synthetic has converted to sludge?

In a 2008 Jetta, 2.5L petrol engine, I started driving more on the highways, and taking longer trips, and noticed a much better mileage than the prior driving that was still mostly highway, but ...
0
votes
1answer
2k views

Car keys off but fuse still lights up the tester when set to ground

So normally when you want to test your fuses, you set the car to on and put the tester clip to ground then put the tester's lead on the fuse. if it lights up then the fuse is working. Well, even when ...
0
votes
1answer
55 views

Aux port '12 Pathfinder not going in all the way

So I have a Pathfinder and the stock has an auxiliary port when I got it (used), but the 3.5 cords that I insert into them doesn't go in all the way, and I'm giving it quite a bit of pressure. I'm not ...
0
votes
2answers
1k views

VW 1.4 TSI EA113 Variations

What does VW do to improve HP and Torque from their 1.4 TSI engine? e.g.: CAXA: 90 KW @ 5000 200 NM @ 1500-4000 CAVD 118 KW @ 5800 240 NM @ 1500-4500
0
votes
1answer
66 views

Craftsman Bolt-Out and similar tools

I've seen Craftsman Bolt-Out mentioned in several questions/threads about removing stuck or rounded-off bolts, a problem I've run into many times. There's no particular problem I'm looking to solve ...
0
votes
1answer
131 views

SD255 vs PMGR Starter - GMC 1998 Suburban

I plan to replace the starter on my Suburban. When I go to BuyAutoParts.com, and fill in the make/model/year http://www.buyautoparts.com/selectpart/1998_GMC/Suburban/Starter/30-0.html I get two ...
0
votes
1answer
440 views

Using clutch and motor brake - good or bad? [duplicate]

Possible Duplicate: Does Downshifting (Engine Braking) Cause Extra Wear and Tear? Edit: As mentioned in the comments: Duplicate of Does Downshifting (Engine Braking) Cause Extra Wear and ...
0
votes
1answer
83 views

What essential preparations should I take before winter driving?

Two years ago I published this blog post on being prepared for the winter, covering off: Practice Planning the route Mechanical Supplies Geek essentials Some of these might be a bit tongue in ...
0
votes
1answer
115 views

“Flight recorder” for automobiles? [closed]

As I sat in traffic court last week for a non-moving violation, many of the cases were clearly he said/she said issues.. particularly with stop sign violations. I can easily see how this specific ...
0
votes
2answers
326 views

How to replace a BMW E36 318 TDS's stereo?

There seem to be tools needed to extract the previous stereo system (K7 + radio) and I have a a doubt about the necessity of unplugging the battery.
0
votes
1answer
522 views

Transmission fluid and filter change: Miles or time? Or both?

I'm pretty sure the service schedule for replacing the transmission filter for a 94-96 B-Body with a 4L60E automatic transmission is an interval in miles only. I don't have the number handy at the ...
0
votes
1answer
603 views

Car driving experience not smooth

My Nissan Altima 2002 (106873 miles). It used to smooth after oil changes. But, I have been noticing that the car is not smooth as it used to be after oil changes. It used to feel like the car was ...
0
votes
1answer
46 views

Noise isolation for 'vanilla' engine

Is it possible to add silicon or other soft devices between the engine of an old car and the chassis, in order to reduce the amount of noise that is transmitted and thus the amount of vibration felt ...
0
votes
2answers
2k views

Hesitation and backfiring on sudden acelleration when warm

I have an old Mitsubishi Triton Utility 1993. It has a 4g54 4 cyl petrol engine with a carby. No computers or anything like that to check error codes. If you press down on the accelerator quickly the ...
0
votes
1answer
408 views

Mazda 3 Rear Sway Bar Bushing Replacement

I'm trying to replace the rear sway bar bushings in my Mazda 3. I have the disassembly manual, and it instructed me on how to remove and replace the bushings, but one of the things it doesn't cover is ...
0
votes
2answers
572 views

How to find ignition wire on mercedes truck

Hi all I need to find ignition wire as I need to connect t to my ower supply. This should be behind the key lock right? How do I approach to it and how to know which one is right wire? Truck s ...

15 30 50 per page