Tools used to repair motor vehicles. Avoid shopping questions.

learn more… | top users | synonyms

7
votes
3answers
822 views

Car enthusiast beginner kit

What is a good place to begin building a kit/set up for performing your own service? For ex: oil changes waxing detailing What is the best starting equipment one can start on?
14
votes
2answers
1k views

Should a mechanical “click” Torque Wrench be set to zero when not in use?

I have a standard click torque wrench. I was told I should set it to zero when not using it in order to keep the accuracy high. Is this true? Secondly, I have not been doing this since I purchased ...
34
votes
5answers
3k views

What is the most efficient method of getting your car unstuck from snow?

If your car is stuck in snow and you don't have any chains, what can be done to get it out? This can be an unnerving problem to have and it happens pretty easily with normal driving on ice. You wind ...
6
votes
1answer
4k views

How important is it to use a real flare nut wrench when removing the fuel line on an old Ford tractor?

An article on overhauling the carbs on a Ford 8N tractor says to use a flare nut wrench to disconnect the fuel line. How important is it use that kind of wrench, vs. an open ended wrench?
5
votes
2answers
719 views

Impact vs. Regular Sockets

What is the difference between impact vs regular ratchet/breaker bar sockets? They look similarly shaped and their corresponding tool drives seem to be of the same dimensions. Are the impact ...
3
votes
1answer
47 views

Better instructions how to use a micrometer

I am confused by these instructions on how to use a micrometer. Does anyone know of better ones? I need to measure the thickness of my valve lifters (and then do a feeler gauge test but that is not ...
3
votes
3answers
2k views

How do I remove a pulley where I have no way of stopping it turning anti-clockwise, like I'm turning the nut?

I've been told I need an airgun, but I have no means of getting one. An alternative is a tool that looks like this. It has a handle of flat steel that splits into a wide U, almost Y shaped but the V ...
1
vote
2answers
254 views

Removing rust / prepping for repainting

I have several developing rust spots on my car. What's the best way to remove the rust / prep the surface? I picked up a wire cup brush with a 1/4", but it's limited to 4,500 RPM. My tool options ...