Multimeters I'm looking for some responses regarding multimeter basics for the site tag-wiki to point OP's at when we want them to use one. The question is; What are the basic functions of a ...
If your car is stuck in snow and you don't have any chains, what can be done to get it out? This can be an unnerving problem to have and it happens pretty easily with normal driving on ice. You wind ...
What is a good place to begin building a kit/set up for performing your own service? For ex: oil changes waxing detailing What is the best starting equipment one can start on?
I have a standard click torque wrench. I was told I should set it to zero when not using it in order to keep the accuracy high. Is this true? Secondly, I have not been doing this since I purchased ...
Background There are quite a few head gasket related questions on the site. Coolant or water in the oil, oil in the coolant or water in a radiator, etc. I'm thinking that some instruction on howto ...
I was building a mount for my custom bobber. My 1/4" carbide drill bit broke off into 3/4" plate of steel. How do I remove it?
How important is it to use a real flare nut wrench when removing the fuel line on an old Ford tractor?
An article on overhauling the carbs on a Ford 8N tractor says to use a flare nut wrench to disconnect the fuel line. How important is it use that kind of wrench, vs. an open ended wrench?
What is the difference between impact vs regular ratchet/breaker bar sockets? They look similarly shaped and their corresponding tool drives seem to be of the same dimensions. Are the impact ...
How do I remove a pulley where I have no way of stopping it turning anti-clockwise, like I'm turning the nut?
I've been told I need an airgun, but I have no means of getting one. An alternative is a tool that looks like this. It has a handle of flat steel that splits into a wide U, almost Y shaped but the V ...
I am confused by these instructions on how to use a micrometer. Does anyone know of better ones? I need to measure the thickness of my valve lifters (and then do a feeler gauge test but that is not ...
I have several developing rust spots on my car. What's the best way to remove the rust / prep the surface? I picked up a wire cup brush with a 1/4", but it's limited to 4,500 RPM. My tool options ...