Suspension is the term given to the system of springs, shock absorbers and linkages that connects a vehicle to its wheels. -Wikipedia

learn more… | top users | synonyms

1
vote
1answer
750 views

Ran over a curb at speed; wheel is bent and rubs against wheelwell on turns

The other day I was doing 30 mph on a downhill road in my Renault Clio 1.2, and went to turn right, but my brakes did not work, and so I just turned into the corner and went straight into and up a ...
3
votes
1answer
53 views

Ford Taurus 01 shock holder problem

My car was making scratchy metal noise when turning left coming from the back. I checked the bottom of the car and found the issue. I don't fully know how to address it what the part's name is and if ...
4
votes
1answer
230 views

Front wheels have different camber after suspension replacement

I recently got my vehicle's front right suspension replaced by some mechanics. Before driving off from the mechanics I had a look at the front and noticed that the right wheel (driver's side) has the ...
2
votes
1answer
793 views

How to Improve Suspension on my bike Honda Shine

My Bike has rear Suspension 3 Step Spring Loaded Hydraulic Shock Absorber & Bike total Weight (kgs) is 122 and its around 3yrs over 90000km run. i didn't feel comfort with suspension as now a days ...
4
votes
4answers
11k views

Clanging in back of Mazda 3

I have a 2007 Mazda 3 sedan with ~100,000 miles on it (it's the 2.0L version). Last October, I noticed a significant clanging noise that was coming from the rear of the vehicle whenever I went over ...
2
votes
1answer
629 views

Front Suspension Rattle (Linked Sound Clip)

I've got a 1994 Nissan pickup. I had new shocks installed about 3 years ago I replaced the ball joints about 2 years ago I replaced the tie rods and front brake calipers about 1 year ago I had the ...
2
votes
1answer
42 views

How to change Ball-Joint with No Motor

I have a 1970 Camaro and put the wrong Ball-Joint in the upper control arm. Does anyone have an idea on how to change it without a motor? I can't drill a hole in the garage floor to anchor the frame. ...
1
vote
4answers
125 views

Is it safe to drive a Fiat Punto with a failing passenger side wishbone?

I've been told by a garage that I need a NSF wishbone due to a knocking noise. The Punto is 13 years old. is it safe to drive until I can get this done?
0
votes
1answer
690 views

Why do i have to service my gearless Honda Activa every 2 weeks

I currently own a Honda Activa which is of a 2007 make. After three years during a heavy traffic jam the conveyer belt got heated up and burnt due to continuous acceleration and braking. I got it ...
4
votes
2answers
2k views

MacPherson strut lower control arm ball joint play and suspension geometry

So I've replaced this ball joint and still get play going over bumps and with the steering wheel turned all the way to one side or another-- you can rock the wheel and get about 15 degrees of play ...
1
vote
1answer
101 views

check vehicular damage on tire bursts

I just experienced having a tire explosion yesterday. I was running at around 60mph and suddenly my rear right tire blew. I was go up a bridge and as it blew, there was brown smoke and I might have ...
1
vote
1answer
3k views

What are the differences between multi-link suspensions and double-wishbone suspensions?

There are a multiple of different kinds of suspension, multi-link suspensions and double-wishbone are popular in some performance groups. What are the main difference between these two? What ...
5
votes
1answer
2k views

What could be causing this bouncing?

I recently took my car to my mechanic for a mandatory inspection for registration. The car is a 2000 Hyundai Elantra. It needed a bit of work to pass and they did the following: replaced one wheel ...
2
votes
2answers
3k views

what is the difference between a 40mm and 60 mm springs

I have a '97 civic sedan. I want to lower the front of my car and lift the rear, or keep it standard. now the body of the car is suspended a little higher than 100mm over the tyre of the car, but it ...
0
votes
1answer
157 views

I feel my shock absorbers are no more working. Need to know if I need to replace them or are there any recommendations to ge them properly repaired?

Pulsar 150CC.. Rear shockers. Bajaj showroom Mechanic suggests to replace them but other mechanic suggests that they can be repaired. it ran around 54K. I am confused now. Please suggest.
3
votes
2answers
4k views

What could cause crackling sounds from a suspension on vehicle start moving?

After a long trip (~500 miles) car started making weird crackling sounds, when it starts moving from full stop. Here's a video, and sounds could be observed from time 00:01, but there are multiple of ...
1
vote
1answer
586 views

1999 Camaro's front wheels move forward and backward significantly, is it the control arms?

I saw someone driving my car today (at the car wash) and I noticed after backing up, upon turning left some and moving forward, the front wheel lagged about 4"!!! It looked like it was going to hit ...
2
votes
2answers
695 views

Lower suspension self locking nut stuck

I'm trying to change the shocks on my 1993 Acura Integra, but I just can't seem to loosen the self-locking nut from the bolt that connects the lower part of the shock to the knuckle. I tried Liquid ...
2
votes
1answer
251 views

Rear suspension much more sensitive to bumps than front

Whenever I drive over speed bumps (or pot holes or whathaveyou) I notice that when the rear wheels go over, the whole car jumps up and down and clatters, a lot more so than the front wheels. I am ...
3
votes
1answer
2k views

Nissan Hardbody Heavy Duty Rear Leaf Springs

My Heavy Duty truck currently has Regular Duty rear leaf springs. The original springs broke when my dad owned the truck and had it a little over loaded. New Heavy Duty springs were too expensive, and ...
4
votes
2answers
199 views

Offroad Kit - Are the brakes replaced?

I have a 2000 Ford Ranger that a previous owner modified by adding an offroad kit to it. I don't have a picture of the suspension system at the moment, but this one is pretty close in terms of wheel ...
3
votes
1answer
749 views

Rattle in my left tire area everytime I brake slowly from more then 80kmh (50mph)?

I have a Chevy Cobalt 2007, and it has been doing this for a while. If I press the brake a little harder, the rattling stops. It doesnt rattle until I press the brake. Leading me to believe there is a ...
3
votes
2answers
4k views

2006 Chevy Cobalt front end (strut mount?) noise

I have a 2006 Chevy Cobalt and since I bought the thing, the front suspension makes this horrible clunking noise every time I go over a bump. I don't know how to describe the noise other than it only ...
1
vote
2answers
291 views

How can I check if my motorcycle's suspension is working correctly?

How can I check if all of my motorcycle's suspension parts are working correctly, and carrying an even load?
2
votes
1answer
468 views

What do I need to put rear shocks on my 1982 Yamaha Maxim XJ 750?

I bought the bike and didn't notice the previous owner had taken the rear shocks off (worst oversight I ever made, kicking myself now). I want to put some shocks on it, but I'm not really sure what I ...
1
vote
4answers
392 views

92 ford escort - Is there a way to remove a ball joint without a pickle fork AND without removing the brakes?

I'm trying to replace the ball joints on my escort but i don't have a pickle fork. Most of the things i've seen so far without the fork require removing the calipers and rotor. Is there another ...
1
vote
2answers
2k views

Shake while braking at certain speeds, intensified with steering input

150k miles 2.0l gas mkIV Jetta, 5-speed manual. Braking at speeds of around 40mph down to 20mph there is shake in steering and overall jerky stopping. If slight steering is added(say gentle ...
2
votes
3answers
1k views

08 f150 with vibration in the front driver side tire when turning left only.

2 months ago I installed a 2 inch suspension lift and replaced upper control arms, tie rods and shocks. The tires were pretty bad and got worse quickly. Vibration and noise started shortly ...
2
votes
1answer
366 views

Had shocks, rear axle, tires replaced - alignment still out of spec and car vibrates?

Last year my old tires became ruined (cupped and feathered) because of ancient, horrible shocks and struts. Since then, I've had all new shocks put in, my rear axle was replaced (because toe couldn't ...
1
vote
1answer
151 views

2011 Ford Fusion bounces on bumps..no leak dealer wont replace struts even though still in warranty

Brought my car 2011 Ford Fusion 4 cyl SEL to the dealer before the 36,000 mile warranty expires because in my opinion the car bounces, it does not absorb the bumps although no problem on the highway. ...
3
votes
1answer
564 views

Rear LCA bushings worn out - better to just replace the whole LCA?

The rear lower control arm bushings on my 92 Civic are badly worn and need to be replaced. I've looked into what's involved in replacing them and it looks like a lot more work than I'd like to do, and ...
2
votes
1answer
2k views

What can cause the squeak sound in the front right when driving faster then 70 km/h

I just have bought a Toyota Yaris of 2007 and observe two things. There is a squeaking sound from right front when driving over 60-70 km/h. Another is when turning wheels right or left completely I ...
3
votes
1answer
1k views

Level control on 2008 Chevy uplander stuck on

Our 2008 Chevy Uplander has an auto levelling system, where if a certain amount of weight is placed in the rear, it will pump air in, or take it out of the rear suspension to keep the vehicle level. ...
6
votes
4answers
283 views

What is a shock absorber?

I was told that I need to replace the shock absorber in my 1992 316i BMW. When I attempt to visit a web site to order the part it does not list any of parts with this name. I know nothing about cars ...
3
votes
1answer
298 views

I get a vibration in steering wheel at highway speed and a knock or clanking noise at slow speeds

I have just had new tires put on and have checked the balance twice and also replaced the lower ball joint and had the new tires aligned. Vibration has become very noticeable. There's no play in the ...
0
votes
1answer
516 views

Mazda 3 Rear Sway Bar Bushing Replacement

I'm trying to replace the rear sway bar bushings in my Mazda 3. I have the disassembly manual, and it instructed me on how to remove and replace the bushings, but one of the things it doesn't cover is ...
1
vote
1answer
624 views

Replacing tie rods on Mazda B4000 (aka Ford Ranger)

I have a 2002 Mazda B4000 with 4wd. The front end is getting a bit loose (recently replaced wheel bearings) and I am thinking about replacing the tie rods and related components prior to taking the ...
7
votes
2answers
2k views

Do I Need to Compress the Springs to Install Strut Tower Braces?

I have a '99 Maxima. I am considering installing strut tower braces. In order to do so, would I need to get spring compression tools to hold the springs on the struts, or will the weight of the car ...
3
votes
2answers
1k views

Why does my 2005 Volvo S60 make a clicking sound when accelerating from a stop?

To start off, I had my oil changed at the dealship last month. The dealer told me that the car needs new joints and control arm bushings. Recently, I've noticed that sometimes there is a click that ...
1
vote
1answer
644 views

Toyota Tacoma squeaky front shock

I recently purchased a Toyota Tacoma 2008. It has a one inch lift kit with aftermarket rims and tires. The problem is that the front shocks squeak loudly when going over a curb for example. Any ideas ...
2
votes
4answers
5k views

In what order does it make sense to upgrade suspension components?

I have recently started competing in autocross. Because of some after-market wheels/tires, which I bought before I started autocross, I can't compete in the Stock class. The class I'm in, Street ...
2
votes
3answers
1k views

2005 chrysler neon clunking noise from front end

My neon has 125000km. Recently started clunking especially over speed bumps - replaced the the lower bushes and shock absorbers but still continues. Related is a Brrrrrr sound on hard acceleration ...
5
votes
2answers
3k views

Replacing front struts on a 2006 Hyundai Sonata

I want to replace the front strut shocks on my 2006 Hyundai Sonata and I'm not sure if I'll need a spring compresser to do this. I have searched the internet for an answer to this question and I ...
1
vote
1answer
630 views

Car shudders when I hit a sharp bump (2003 Maxima)

I have a 2003 Nissan Maxima SE and I've noticed that when I hit a sharp bump (like a shallow pothole) that the car seems to shudder or vibrate for a second. The car just hit 100k miles on the ...
2
votes
3answers
1k views

Front End Alignments

I recently had my vehicle in for a front end alignment. They told me all of my shocks were bad, causing all of the problems, and that they would not be able to align the front end with those bad ...
3
votes
1answer
567 views

Would changing to an air suspension give a smoother ride?

The road here can be a little bit rough sometimes, so I was wondering how I could improve the ride. How about upgrading to an air suspension system? Would that improve the ride? How much would such a ...
2
votes
2answers
91 views

Installing ubolts - How to push the slip joint forward

I'm in the process of removing the lift blocks from my 2000 silverado z71. Now that I'm ready to install new ubolts I've realized that the driveshaft and axle have slipped backwards away from the ...
1
vote
1answer
213 views

Are these upper ball joints universal (driver/passenger side) or is it a mistake?

I have this 1994 Ford Crown Victoria (police interceptor). I wanted to replace upper ball joints but there's this thing I can't understand. On ebay and other part dealers websites, some uppper ball ...
3
votes
1answer
2k views

How to diagnose “Creaking” / “Scraping” sound when entering parking lots?

My drive to work involved entering a lot that has a fairly steep grade compared to the pavement. As such, in low riding vehicles, you need to enter it fairly slowly. The thing is, recently, I can ...
0
votes
1answer
153 views

Banging/Snapping Sound When Turning ('04 TrailBlazer)

I'm thinking that this is the sway bar or sway bar links. Does this sound right? This happens often and it doesn't matter which way I turn.