The tag has no wiki summary.

learn more… | top users | synonyms

4
votes
1answer
104 views

Removing difficult engine bolts

Currenly trying to remove part of the engine mount off my Vauxhall Astra to get to the thermostat and I've hit a stumbling block by two VERY tight screws that are almost impossible to get a wrench on ...
4
votes
2answers
875 views

Removing badly rusted and broken bolt from suspension

I'm stuck trying to replace the rear lower control arms on my 92 Civic. One of the bolts was broken, and while I've now gotten the old arm off by taking a Dremel to the bushing and bolt, part of the ...
4
votes
1answer
141 views

Options for replacing rusted exhaust mounting bolts

The car is a 2005 Mini Cooper. The bolts that hold the exhaust mounts in place have rusted and snapped on both sides: I've taken up the floor of the boot and have located their heads on either ...
3
votes
1answer
80 views

How to reach bolt at the rear of BMW M41 Engine?

I can't manage to properly reach the top right screw (zoom picture of it on the second picture). How could I do that ? (the tool I have is too long to be able to go on the rear, there is nearly no ...
2
votes
1answer
3k views

Best way to remove partially stripped and rusted fuel filter nut?

I missed the memo about replacing my fuel filter every 30k, so it's been more like 100k since it's been replaced. Anyway, the car is a 2001 Buick Regal, and the fuel filter nut (not the quick connect, ...
2
votes
2answers
173 views

What tools are needed for removing rusted bolts?

Will be removing at least some heat shielding if not also the headers from a Subaru Outback. The car spent the first 6 years of its life in PA and has an excessive amount of rust on the bolts that ...
2
votes
1answer
129 views

Remove stuck steering gearbox mounting bolt?

I'm removing the steering gearbox from my 2004 E-250. I'm trying to remove the gearbox from the frame, but one of the three bolts that mount it to the frame is stuck. I've managed to get the bolt ...
2
votes
1answer
147 views

Undoing a rounded-off triple-square bolt

I rounded off a triple-square bolt while trying to undo it with a regular 6-point Torx bit. How can I undo it without resorting to purchasing a dedicated triple-square bit? The bolt is done up with ...
2
votes
3answers
1k views

Remove rounded manifold bolt

I'm trying to take off the manifold bolts on an old Chevy 350 (the ones that connect the manifold to the header). I got 4 out of the 6 bolts out, but 2 are extremely struck and rounded due to all the ...
0
votes
2answers
44 views

Stripped exhaust bolt

I got an exhaust I was putting on my car (2013 wrx) and had to disconnect the exhaust after the midpipe. The bolts were rusted so I pb blasted them, and then got one set of bolts off. When I went to ...
0
votes
0answers
55 views

Craftsman Bolt-Out and similar tools

I've seen Craftsman Bolt-Out mentioned in several questions/threads about removing stuck or rounded-off bolts, a problem I've run into many times. There's no particular problem I'm looking to solve ...